Related papers: Wireless Energy Beamforming Using Signal Strength …
In this paper, we investigate a multiuser distributed antenna system with simultaneous wireless information and power transmission under the assumption of imperfect channel state information (CSI). In this system, a distributed antenna port…
A systematic design of adaptive waveform for Wireless Power Transfer (WPT) has recently been proposed and shown through simulations to lead to significant performance benefits compared to traditional non-adaptive and heuristic waveforms. In…
The end-to-end learning of Simultaneous Wireless Information and Power Transfer (SWIPT) over a noisy channel is studied. Adopting a nonlinear model for the energy harvester (EH) at the receiver, a joint optimization of the transmitter and…
Simultaneous wireless information and power transfer (SWIPT) has been envisioned as a promising technology to support ubiquitous connectivity and reliable sustainability in Internet-of-Things (IoT) networks, which, however, generally…
In this paper, we propose a joint beamforming algorithm for a multiuser wireless information and power transfer (MU-WIPT) system that is compatible with the conventional multiuser multiple input multiple output (MU-MIMO) system. The…
In this paper, we study the waveform and passive beamforming design for intelligent reflecting surface (IRS)-aided wireless power transfer (WPT). Generalized multi-user and low complexity single-user algorithms are derived based on…
In this paper, we investigate the design of energy-efficient beamforming for an ISAC system, where the transmitted waveform is optimized for joint multi-user communication and target estimation simultaneously. We aim to maximize the system…
This paper addresses a drawback of massive multiple-input multiple-output Maximum Ratio Transmission beamforming. In some propagation conditions, when the base station serves the same target user equipment for a long period, it reduces the…
In this paper, we study the waveform design problem for a single-input single-output (SISO) radio-frequency (RF) wireless power transfer (WPT) system in frequency-selective channels. First, based on the actual non-linear current-voltage…
One of the major challenges in design of Wireless Sensor Networks (WSNs) is to reduce energy consumption of sensor nodes to prolong lifetime of finite-capacity batteries. In this paper, we propose Energy-efficient Adaptive Scheme for…
In this paper, we study a multi-sine multiple-input multiple-output (MIMO) wireless power transfer (WPT) system with the objective to increase the output DC power. We jointly optimize the multi-sine waveform and beamforming accounting for…
Radio-frequency (RF) signals enabled wireless information and power transfer (WIPT) is a cost-effective technique to achieve two-way communications and at the same time provide energy supplies for low-power wireless devices. However, the…
A multiple antenna base station (BS) with an intelligent reflecting surface (IRS) platform, and several single antenna users are considered in the downlink mode. Simultaneous wireless information and power transfer (SWIPT) is utilized by…
This paper studies energy-efficient joint transmit and receive beamforming in multi-cell multi-user multiple-input multiple-output systems. We consider conventional network energy efficiency metric where the users can receive unicasting…
This paper presents the concept, design, channel modeling, beamforming algorithm development, prototype fabrication, and experimental measurement of an electromagnetically reconfigurable fluid antenna system (ER-FAS), in which each FAS…
We consider a point-to-point system with simultaneous wireless information and power transfer (SWIPT) over a block fading channel. Each transmission block consists of a training phase and a data transmission phase. Pilot symbols are…
A new line of research on communications and signals design for Wireless Power Transfer (WPT) has recently emerged in the communication literature. Promising signal strategies to maximize the power transfer efficiency of WPT rely on…
Radio frequency (RF) wireless power transfer (WPT) is a promising technology to seamlessly charge low-power devices, but its low end-to-end power transfer efficiency remains a critical challenge. To address the latter, low-cost…
Reconfigurable intelligent surface (RIS) can effectively control the wavefront of the impinging signals and has emerged as a cost-effective promising solution to improve the spectrum and energy efficiency of wireless systems. Most existing…
Far-field Wireless Power Transfer (WPT) has emerged as a potential power source for the Internet of Things (IoT) and Wireless Sensor Network (WSN).The expansion of the power transfer range is one of the key challenges to make the technology…