Related papers: Combination of frequency shift and impedance-based…
A new type of quartz resonance device for measurements of oscillations of the contact potential difference induced by modulated light is described. Special attention is devoted to the compensation of the constructive capacitance of the…
An integrated and automated smart structures approach for structural health monitoring is presented, utilizing an array of piezoelectric transducers attached to or embedded within the structure for both actuation and sensing. The system…
Accurate temperature measurements are essential for the proper monitoring and control of industrial furnaces. However, measurement uncertainty is a risk for such a critical parameter. Certain instrumental and environmental errors must be…
An impedance spectroscopy (IS) is a versatile tool to study the effect of grains (bulk), grain boundaries and electrode-electrolyte interface on dielectric and electrical properties of electro-ceramics. This study only focuses the high…
LISA Pathfinder (LPF) was a technology pioneering mission designed to test key technologies required for gravitational wave detection in space. In the low frequency regime (milli-Hertz and below), where space-based gravitational wave…
We consider the question: Is it possible to measure two temperatures simultaneously using a single thermometer? Under common circumstances, where the thermometer can interact with only one bath at a time and the interaction leads to…
The thermal sensitive electrical parameter (TSEP) method is crucial for enhancing the reliability of power devices through junction temperature monitoring. The TSEP method comprises three key processes: calibration, regression, and…
Quantifying the temperature of microdevices is critical for probing nanoscale energy transport.Such quantification is often accomplished by integrating resistance thermometers into microdevices. However, such thermometers frequently become…
In this work, we report the fabrication of a high temperature measurement setup to measure Figure of merit (ZT). This setup facilitates the simultaneous measurement of Seebeck coefficient ({\alpha}), thermal conductivity (\kappa), and…
The paper deals with an empirical validation of a building thermal model. We put the emphasis on sensitivity analysis and on research of inputs/residual correlation to improve our model. In this article, we apply a sensitivity analysis…
We introduce a temperature-dependent parameterization in the modified embedded-atom method and combine it with molecular dynamics to simulate the diverse physical properties of the \delta - and \epsilon - phases of elemental plutonium. The…
The thermal response function given to a unit-step dissipation accurately characterizes the thermal system. Instead of the thermal response function the so-called structure function describing three-dimensional as the equivalent model of…
Specific conductance and frequency-dependent resistance (impedance) data are widely utilized for understanding the physicochemical characteristics of aqueous and non-aqueous fluids and for evaluating the performance of chemical processes.…
This work builds on the previous introduction [1] of a coupled experimental-computational system devised to fully characterize the thermal behavior of complex 3D submicron electronic devices. The new system replaces the laser-based surface…
It is well known that sensors using strain gauges have a potential dependency on temperature. This creates temperature drift in the measurements of six axis force torque sensors (F/T). The temperature drift can be considerable if an…
We present a method to estimate the amount of squeezing and temperature of a single-mode Gaussian harmonic oscillator state based on the weighted least squares estimator applied to measured Fock state populations. Squeezing and temperature,…
This study aims to enhance the accuracy of a six-axis force/torque sensor compared to existing approaches that utilize Multi-Layer Perceptron (MLP) and the Least Square Method. The sensor used in this study is based on a photo-coupler and…
Gravimeters fabricated with MEMS suffer from temperature-dependent drifts in their long-term stability. We analyze the thermal contributions to the signal, and we propose three mechanisms to mitigate their effects. The first one uses…
Frequency-selective or even frequency-tunable Terahertz (THz) photodevices are critical components for many technological applications that require nanoscale manipulation, control and confinement of light. Within this context, gate-tunable…
We explore layered strongly correlated materials as a platform to identify and control unconventional heat transfer phenomena. We demonstrate that these systems can be tailored to sustain a wide spectrum of heat transport regimes, ranging…