Related papers: Intentional Aliasing Method to Improve Sub-Nyquist…
Continuous phase modulation (CPM) with 1-bit quantization at the receiver is promising in terms of energy and spectral efficiency. In this study, CPM waveforms with symbol durations significantly shorter than the inverse of the signal…
Motivated by the inquiries of weak signals in underpowered genome-wide association studies (GWASs), we consider the problem of retaining true signals that are not strong enough to be individually separable from a large amount of noise. We…
To ensure reliable communication in randomly varying and error-prone channels, wireless systems use adaptive modulation and coding (AMC) as well as hybrid ARQ (HARQ). In order to elucidate their compatibility and interaction, we compare the…
Analog-to-digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) communication systems with large number of antennas. Use of low resolution ADCs has been proposed as a means to…
Multiple-input multiple-output (MIMO) wireless systems conventionally use high-resolution analog-to-digital converters (ADCs) at the receiver side to faithfully digitize received signals prior to digital signal processing. However, the…
Millimeter wave (mmWave) MIMO will likely use hybrid analog and digital precoding, which uses a small number of RF chains to avoid energy consumption associated with mixed signal components like analog-to-digital components not to mention…
Nowadays, millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems is a favorable candidate for the fifth generation (5G) cellular systems. However, a key challenge is the high power consumption imposed by its numerous…
In this letter, a permutation enhanced parallel reconstruction architecture for compressive sampling is proposed. In this architecture, a measurement matrix is constructed from a block-diagonal sensing matrix and the sparsifying basis of…
Measurement-based quantum computation (MBQC) is a framework for quantum information processing in which a computational task is carried out through one-qubit measurements on a highly entangled resource state. Due to the indeterminacy of the…
Sampling a signal below the Shannon-Nyquist rate causes aliasing, meaning different frequencies to become indistinguishable. It is also well-known that recovering spectral information from a signal using a parametric method can be ill-posed…
We propose a joint source-channel-network coding scheme, based on compressive sensing principles, for wireless networks with AWGN channels (that may include multiple access and broadcast), with sources exhibiting temporal and spatial…
Conventional Synthetic Aperture Radar (SAR) systems are limited in their ability to satisfy the increasing requirement for improved spatial resolution and wider coverage. The demand for high resolution requires high sampling rates, while…
Wilkinson conversion of stored samples in large Switch Capacitor Array (SCA) ASICs, such as used for high speed waveform sampling, has many benefits in terms of compactness, no missing output codes, low power requirements and robustness.…
This work proposes a blind adaptive reduced-rank scheme and constrained constant-modulus (CCM) adaptive algorithms for interference suppression in wireless communications systems. The proposed scheme and algorithms are based on a two-stage…
Automatic Modulation Classification (AMC) is a signal processing technique widely used at the physical layer of wireless systems to enhance spectrum utilization efficiency. In this work, we propose a fast and accurate AMC system, termed…
Multiple-antenna systems is a key technique to serve multiple users in future wireless systems. For low energy consumption and hardware complexity we first consider transmit symbols with constant magnitude and then 1-bit digital-to-analog…
Utilizing intelligent reflecting surface (IRS) was proven to be efficient in improving the energy efficiency for wireless networks. In this paper, we investigate the passive beamforming and channel estimation for IRS assisted wireless…
Analog to digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) receivers in large bandwidth millimeter-wave systems. Prior works have considered two mitigating solutions to…
In superconducting electronics, the ability to control the frequency of microwave wave packets is crucial for several applications, such as the operation of superconducting quantum processors and the readout of superconducting sensors. We…
This letter presents an adaptive spectrum sensing algorithm that detects wideband spectrum using sub-Nyquist sampling rates. By taking advantage of compressed sensing (CS), the proposed algorithm reconstructs the wideband spectrum from…