Related papers: Distributed Coordinated Multicell Beamforming for …
Dynamic Metasurface Antennas (DMAs) constitute a promising solution for extremely large antenna arrays, requiring lower power consumption and reduced hardware cost as compared to conventional phased arrays. In this paper, we consider a…
The amalgamation of cell-free networks and reconfigurable intelligent surface (RIS) has become a prospective technique for future sixth-generation wireless communication systems. In this paper, we focus on the precoding and beamforming…
Intelligent reflecting surface (IRS) has been considered as a revolutionary technology to enhance the wireless communication performance. To cater for multiple mobile users, adjusting IRS beamforming patterns over time, i.e., dynamic IRS…
AC/multi-terminal DC (MTDC) hybrid power systems have emerged as a solution for the large-scale and longdistance accommodation of power produced by renewable energy systems (RESs). To ensure the optimal operation of such hybrid power…
We study physical layer multicasting in multicell networks where each base station, equipped with multiple antennas, transmits a common message using a single beamformer to multiple users in the same cell. We investigate two coordinated…
Reconfigurable intelligent surface (RIS)-aided cell-free (CF) massive multiple-input multiple-output (mMIMO) is a promising technology for further improving spectral efficiency (SE) with low cost and power consumption. However, conventional…
Hybrid precoders and combiners are designed for cooperative cell-free multi-user millimeter wave (mmWave) multiple-input multiple-output (MIMO) cellular networks for low complexity interference mitigation. Initially, we derive an optimal…
Full duplex (FD) is an auspicious wireless technology that holds the potential to double data rates through simultaneous transmission and reception. This paper proposes two innovative designs of hybrid beamforming (HYBF) for a multicell…
Non-terrestrial base stations (NTBSs), including high-altitude platform stations (HAPSs) and hot-air balloons (HABs), are integral to next-generation wireless networks, offering coverage in remote areas and enhancing capacity in dense…
Broad beam beamforming (BF) design in multiple-input multiple-output (MIMO) can be convenient for initial access, synchronization, and sensing capabilities in cellular networks by avoiding overheads of sweeping methods while making…
The technology of Reconfigurable Intelligent Surfaces (RISs) has lately attracted considerable interest from both academia and industry as a low-cost solution for coverage extension and signal propagation control. In this paper, we study…
With the dense deployment of small cell networks, low-cost backhaul schemes for small cell base stations (SBSs) have attracted great attentions. Self-backhaul using cellular communication technology is considered as a promising solution.…
Multicell coordinated beamforming (MCBF) has been recognized as a promising approach to enhancing the system throughput and spectrum efficiency of wireless cellular systems. In contrast to the conventional single-cell beamforming (SBF)…
The cell-free networking paradigm constitutes a revolutionary architecture for future generations of wireless networks, which has been recently considered in synergy with Reconfigurable Intelligent Surfaces (RISs), a promising…
The sixth-generation (6G) wireless networks will rely on ultra-dense multi-cell deployment to meet the high rate and connectivity demands. However, frequency reuse leads to severe inter-cell interference, particularly for cell-edge users,…
Reconfigurable Intelligent Surfaces (RISs) are one of the key emerging 6th Generation (6G) technologies that are expected to improve the link budgets between transmitters and receivers by adding artificial propagation paths. In such…
Multicast beamforming is a key technology for next-generation wireless cellular networks to support high-rate content distribution services. In this paper, the coordinated downlink multicast beamforming design in multicell networks is…
This paper investigates the problem of resource allocation for multiuser communication networks with a reconfigurable intelligent surface (RIS)-assisted wireless transmitter. In this network, the sum transmit power of the network is…
Modern wireless communication networks, particularly cellular networks utilize multiple antennas to improve the capacity and signal coverage. In these systems, typically an active transceiver is connected to each antenna. However, this…
A simple feedback control algorithm is presented for distributed beamforming in a wireless network. A network of wireless sensors that seek to cooperatively transmit a common message signal to a Base Station (BS) is considered. In this…