Related papers: A Low-cost Environmental Control System for Precis…
An electron-tracking Compton camera (ETCC) is a detector that can determine the arrival direction and energy of incident sub-MeV/MeV gamma-ray events on an event-by-event basis. It is a hybrid detector consisting of a gaseous time…
Transition-edge sensors (TESs) are capable of highly accurate single particle energy measurement. TESs have been used for a wide range of photon detection applications, particularly in astronomy, but very little consideration has been given…
We report the design and implementation of a point-contact spectroscopy (PCS) system integrated with a dilution refrigerator, enabling measurements down to 30 mK. The setup employs a needle-anvil geometry with a cryogenic piezo-driven…
Microelectromechanical systems (MEMS) have been applied to many measurement problems in physics, chemistry, biology and medicine. In parallel, cavity optomechanical systems have achieved quantum-limited displacement sensitivity and ground…
In this paper, our objective is to design, build, and verify a closed-loop environmental control system tailored for small-scale agriculture applications. This project aims to develop a low-cost, safety-critical embedded solution using the…
One of the main objectives of the LHD is to extend the plasma confinement database for helical systems and to demonstrate such extended plasma confinement properties to be sustained in steady state. Among the various plasma parameter…
This paper deals with a single-crystal-silicon (SCS) MEMS resonator with improved temperature stability. While simulations have shown that the temperature coefficient of resonant frequency can be down to 1 ppm/degrees C, preliminary…
Calorimetric decay energy spectroscopy of electron-capture-decaying isotopes is a promising method to achieve the sensitivity required for electron neutrino mass measurement. The very low total nuclear decay energy (QEC < 3 keV) and short…
High precision radial velocity (RV) measurements in the near infrared are on high demand, especially in the context of exoplanet search campaigns shifting their interest to late type stars in order to detect planets with ever lower mass or…
Gravimeters are devices which measure changes in the value of the gravitational acceleration, \textit{g}. This information is used to infer changes in density under the ground allowing the detection of subsurface voids; mineral, oil and gas…
A stochastic model predictive controller (SMPC) of air conditioning (AC) system is proposed to improve the energy efficiency of electric vehicles (EV). A Markov-chain based velocity predictor is adopted to provide a sense of the future…
We present a comprehensive analysis of high-resolution transition-edge sensors (TESs) as a quantum sensing platform for detecting dark matter (DM). Operating near the thermodynamic noise limit with sub-eV energy resolution, TESs offer a…
Uniform large transition-edge sensor (TES) arrays are fundamental for the next generation of X-ray space observatories. These arrays are required to achieve an energy resolution $\Delta E$ < 3 eV full-width-half-maximum (FWHM) in the soft…
Recent advances in increasing the spectroscopic energy resolution in scanning tunneling microscopy (STM) have been achieved by integrating electron spin resonance (ESR) with STM. Here, we demonstrate the design and performance of a…
The EDGES High-Band experiment aims to detect the sky-average brightness temperature of the $21$-cm signal from the Epoch of Reionization (EoR) in the redshift range $14.8 \gtrsim z \gtrsim 6.5$. To probe this redshifted signal, EDGES…
The innermost part of the ATLAS experiment will be a pixel detector containing around 1750 individual detector modules. A detector control system (DCS) is required to handle thousands of I/O channels with varying characteristics. The main…
The Kepler mission has provided a treasure trove of eclipsing binaries (EBs), observed at extremely high photometric precision, nearly continuously for several years. We are carrying out a survey of ~100 of these EBs to derive dynamical…
We describe a general radiative equilibrium and temperature correction procedure for use in Monte Carlo radiation transfer codes with sources of temperature-independent opacity, such as astrophysical dust. The technique utilizes the fact…
The coherence properties of optical emitters in crystals are crucial for quantum technologies and optical frequency metrology. Cooling to sub-kelvin temperatures can markedly enhance coherence, making it important to identify the parameters…
An environmental cell high resolution electron microscope (EHREM) has been developed for in situ studies of dynamic chemical reactions on the atomic scale. It allows access to metastable intermediate phases of catalysts and to sequences of…