Related papers: Benchmarking five numerical simulation techniques …
A two-dimensional photonic crystal microcavity design supporting a wavelength-scale volume resonant mode with a calculated quality factor (Q) insensitive to deviations in the cavity geometry at the level of Q~2x10^4 is presented. The…
In this paper, we propose a microcavity supported by a designed photonic crystal structure (PhC) that supplies both tunability of cavity modes and quality factor of cavity. Low symmetric defect region provides a trigger effect for the…
Optical resonances in 1D photonic crystal microcavities are investigated numerically using finite-element light scattering and eigenmode solvers. The results are validated by comparison to experimental and theoretical findings from the…
We report on the spectroscopic investigation of quantum dot - micropillar cavities with unprecedented quality factors. We observe a pronounced dependency of the quality factor on the measurement scheme, and find that significantly larger…
The correct numerical calculation of the resonance characteristics and, principally, the quality factor $Q$ of contemporary photonic and plasmonic resonant systems is of utmost importance, since $Q$ defines the bandwidth and affects…
We demonstrate that the resonance frequencies of high-Q microcavities in two-dimensional photonic crystal membranes can be tuned over a wide range by introducing a subwavelength dielectric tip into the cavity mode. Three-dimensional…
We show the strength of the Fourier modal method (FMM) for numerically investigating the optical properties of vertical cavities including subwavelength gratings. Three different techniques for determining the resonance frequency and…
We propose and experimentally demonstrate a photonic crystal nanocavity with multiple resonances that can be tuned nearly independently. The design is composed of two orthogonal intersecting nanobeam cavities. Experimentally, we measure…
We describe a general recipe for designing high-quality factor (Q) photonic crystal cavities with small mode volumes. We first derive a simple expression for out-of-plane losses in terms of the k-space distribution of the cavity mode. Using…
We investigate the quality (Q) factor and the mode dispersion of single-defect nanocavities based on a triangular-lattice GaAs photonic-crystal (PC) membrane, which contain InAs quantum dots (QDs) as a broadband emitter. To obtain a high Q…
Devices based on two-dimensional photonic-crystal (2D-PC) nanocavities, which are defined by their air hole patterns, usually require a high quality (Q) factor to achieve high performance. We demonstrate that hole patterns with very high Q…
The spectra of two-dimensional photonic crystal slab nanocavities with embedded InAs quantum dots are measured by photoluminescence and reflectance. In comparing the spectra taken by these two different methods, consistency with the…
Sub-threshold measurements of a photonic crystal (PC) microcavity laser operating at 1.3 microns show a linewidth of 0.10 nm, corresponding to a quality factor Q ~ 1.3x10^4. The PC microcavity mode is a donor-type mode in a graded square…
We report the optimisation of optical properties of single defects in three-dimensional (3D) face-centred-cubic (FCC) woodpile photonic crystal (PC) cavities by using plane-wave expansion (PWE) and finite-difference time-domain (FDTD)…
Efficient micro-resonators simultaneously require a large quality factor $Q$ and a small volume $V$. However, the former is ultimately limited by bending losses, the unavoidable radiation of energy of a wave upon changing direction of…
We investigate the design, fabrication and experimental characterization of high Quality factor photonic crystal nanobeam cavities in silicon. Using a five-hole tapered 1D photonic crystal mirror and precise control of the cavity length, we…
One dimensional nano-beam photonic crystal cavities fabricated in silicon dioxide are considered in both simulation and experiment. Quality factors of over 10^4 are found via simulation, while quality factors of over 5*10^3 are found in…
A two-dimensional photonic crystal semiconductor microcavity with a quality factor Q ~ 40,000 and a modal volume Veff ~ 0.9 cubic wavelengths is demonstrated. A micron-scale optical fiber taper is used as a means to probe both the spectral…
An H1 photonic crystal nanocavity is based on a single point defect and has eigenmodes with a variety of symmetric features. Thus, it is a promising building block for photonic tight-binding lattice systems that can be used in studies on…
We experimentally demonstrated high quality factors (Q-factors) of nanocavities in three-dimensional photonic crystals by increasing the in-plane area of the structure. Entire structures made of GaAs were fabricated by a micro-manipulation…