Related papers: Design and Simulation of a Highly Sensitive Refrac…
In this paper, a tunable plasmonic refractive index sensor with nanoring-strip graphene arrays is numerically investigated by the finite difference time domain (FDTD) method. The simulation results exhibit that by changing the sensing…
Miniaturized, low-cost wavelength detectors are gaining enormous interest as we step into the new age of photonics. Incompatibility with integrated circuits or complex fabrication requirement in most of the conventionally used filters…
Optical interconnects have attracted significant research interest for use in short-reach board-level optical communication links in supercomputers and data centres. Multimode polymer waveguides in particular constitute an attractive…
White light spectral interferometry is applied to measure the refractive index in absorbing liquids in the spectral range from 400 to 1000 nm. We analyze the influence of absorption on the visibility of interferometric fringes and,…
We study the conductivity of a strongly coupled striped superconductor using gauge/gravity duality (holography). The study is done analytically, in the large modulation regime. We show that the optical conductivity is inhomogeneous but…
Investigations into the propagation characteristics, specifically loss and wave velocity, of superconducting coplanar waveguides and microstrip lines were conducted at a 2 mm wavelength. This was achieved through the measurement of on-chip…
Resistance thermometry provides a time-tested method for taking temperature measurements. However, fundamental limits to resistance-based approaches has produced considerable interest in developing photonic temperature sensors to leverage…
A method to engineer the refractive indices of functional materials (TiO2, ZnO, SnO2, SiO2), by nanostructuring in the deep sub-wavelength regime (<20nm), is presented. Block-copolymer templating combined with a wet processing route is used…
This paper presents an electrolytically gated broadband microwave sensor where atomically-thin graphene layers are integrated into coplanar waveguides and coupled with microfluidic channels. The interaction between a solution under test and…
Herein, the concept of point of darkness based on polarized light phase difference and absorption of light is demonstrated by simulations using low refractive index and extinction coefficient semiconductor and dielectric, and high…
Waveguide mirrors possess nano-structured surfaces which can potentially provide a significant reduction in thermal noise over conventional dielectric mirrors. To avoid introducing additional phase noise from motion of the mirror transverse…
The micro-cavity is a promising sensor platform, any perturbation would disturb its linewidth, cause resonance shift or splitting. However, such sensing resolution is limited by the cavity's optical quality factor and mode volume. Here we…
We have been developing a CdZnTe immersion grating for a compact high-dispersion mid-infrared spectrometer (wavelength range 10--18 $\mu$m, spectral resolution $R = \lambda/\Delta \lambda > 25,000$, operating temperature $T < 20$ K). Using…
Graphene based photo-detecting has received great attentions and the performance of such detector is stretching to both ends of high sensitivity and ultra-fast response. However, limited by the current photo-gating mechanism, the price for…
Mid-infrared absorption spectroscopy is a well-established technique for non-destructive quantitative molecular analysis. Waveguide-integrated sensors provide a particularly compact solution operating with reduced sample volumes while…
In this work, a refractive index (RI) sensor with an effective integration of colorimetric detection and optical sensing capabilities has been developed. Colorimetric detection relies on the sensitivity of the structural color of photonic…
A radio-frequency (rf) matching circuit with an in situ tunable varactor diode used for rf reflectometry measurements in semiconductor nanostructures is investigated and used to optimize the sample-specific chip design. The samples are…
The use of relatively simple structures to achieve high performance refractive index sensors has always been urgently needed. In this work, we propose a lithography-free sensing platform based on metal-dielectric cavity, the sensitivity of…
We proposed a refractive index (RI) sensing method with temperature compensation by using an optical frequency comb (OFC) sensing cavity employing a multimode-interference (MMI) fiber, namely, the MMI-OFC sensing cavity. The MMI-OFC sensing…
We present experimental results for a fully etched C-band grating coupler with reduced back reflection fabricated in an 800 nm silicon nitride platform. Back-reflections are reduced by symmetrically interrupting the first few grates around…