Related papers: Energy efficiency of mmWave massive MIMO precoding…
In this paper, we study the performance of cooperative millimeter wave (mmWave) networks with hybrid precoding architectures. Considering joint transmissions and BS silence strategy, we propose hybrid precoding algorithms which minimize the…
In this paper, we focus on the design of the hybrid analog/digital precoding in millimeter wave multiple-input multiple-output (MIMO) systems. To reduce the feedback overhead, we propose two non-uniform quantization (NUQ) codebook based…
Wireless power transfer (WPT) has garnered increasing attention due to its potential to eliminate device-side batteries. With the advent of (distributed) multiple-input multiple-output (MIMO), radio frequency (RF) WPT has become feasible…
In the Fifth generation (5G) wireless communication systems, a majority of the traffic demands is contributed by various multimedia applications. To support the future 5G multimedia communication systems, the massive multiple-input…
Practical hardware limitations often impose a reduced number of available phase shifts at the elements of a reconfigurable intelligent surface (RIS). Most works often assume continuous phase-shits at the RIS elements for the transmit and…
In the design of wireless systems, quantization plays a critical role in hardware, which directly affects both area efficiency and energy efficiency. Being an enabling technique, the wide applications of multiple-input multiple-output…
With the turn of new decade, wireless communications face a major challenge on connecting many more new users and devices, at the same time being energy efficient and minimizing its carbon footprint. However, the current approaches to…
In this paper, we consider a generalized sub-array-connected (GSAC) architecture for arbitrary radio frequency (RF) chain and antenna configurations, where the number of RF chains connected to a sub-array and the number of antennas in each…
Massive multiple-input multiple-output (MIMO) is expected to be a vital component in future 5G systems. As such, there is a need for new modeling in order to investigate the performance of massive MIMO not only at the physical layer, but…
Hybrid analog/digital architectures and receivers with low-resolution analog-to-digital converters (ADCs) are two low power solutions for wireless systems with large antenna arrays, such as millimeter wave and massive MIMO systems. Most…
In this article we compare the performance of two typical hyrbid beamforming structures for multiuser massive MIMO systems, i.e., the full- and partial-connection structures. Under the assumption of small angular spread for mmWave channels,…
Multiple-input multiple-output (MIMO) systems greatly increase the overall throughput of wireless systems since they are capable of transmitting multiple streams employing the same time-frequency resources. However, this gain requires an…
In this letter, we study the analogue pre/post-coding vector design for a point-to-point multiple-input multiple-output (MIMO) system with 1-bit phase shifters. Specifically, we focus on the signal-to-noise ratio (SNR) maximization problem…
In this paper, we investigate a multiple-input multiple-output (MIMO) system with simultaneous information detection (ID) and energy harvesting (EH) receiver. This point-to-point system operates in the vicinity of active interfering nodes.…
Massive MIMO is a compelling wireless access concept that relies on the use of an excess number of base-station antennas, relative to the number of active terminals. This technology is a main component of 5G New Radio (NR) and addresses all…
In the conventional multiuser MIMO systems, user selection and scheduling has previously been used as an effective way to increase the sum rate performance of the system. However, the recent concepts of the massive MIMO systems (at…
This paper addresses the design of transmit precoder and receive combiner matrices to support $N_{\rm s}$ independent data streams over a time-division duplex (TDD) point-to-point massive multiple-input multiple-output (MIMO) channel with…
The power consumption of high-speed, high-resolution analog to digital converters (ADCs) is a limiting factor in implementing large-bandwidth mm-wave communication systems. A mitigating solution, which has drawn considerable recent…
We propose practical transceiver structures for double-sided massive multiple-input-multiple-output (MIMO) systems. Unlike standard massive MIMO, both transmit and receive sides are equipped with high-dimensional antenna arrays. We leverage…
Motivated by the demand for energy-efficient communication solutions in the next generation cellular network, a mixed-ADC receiver architecture for massive multiple input multiple output (MIMO) systems is proposed, which differs from…