Related papers: Energy efficiency of mmWave massive MIMO precoding…
Signal processing in wireless communications, such as precoding, detection, and channel estimation, are basically about solving inverse matrix problems, which, however, are slow and inefficient in conventional digital computers, thus…
Channel estimation is useful in millimeter wave (mmWave) MIMO communication systems. Channel state information allows optimized designs of precoders and combiners under different metrics such as mutual information or…
Hybrid analog/digital precoding offers a compromise between hardware complexity and system performance in millimeter wave (mmWave) systems. This type of precoding allows mmWave systems to leverage large antenna array gains that are…
Energy in today's short-range wireless communication is mostly spent on the analog- and digital hardware rather than on radiated power. Hence, purely information-theoretic considerations fail to achieve the lowest energy per information bit…
The massive multiple-input multiple-output (MIMO) transmission technology has recently attracted much attention in the non-geostationary, e.g., low earth orbit (LEO) satellite communication (SATCOM) systems since it can significantly…
In multi-user millimeter wave (mmWave) multiple-input-multiple-output (MIMO) systems, hybrid precoding is a crucial task to lower the complexity and cost while achieving a sufficient sum-rate. Previous works on hybrid precoding were usually…
This letter investigates the uplink of a multi-user millimeter wave (mmWave) system, where the base station (BS) is equipped with a massive multiple-input multiple-output (MIMO) array and resolution-adaptive analog-to-digital converters…
Using multiple-input multiple-output (MIMO) with orthogonal frequency division multiplexing (OFDM) for integrated sensing and communication (ISAC) has attracted considerable attention in recent years. While most existing works focus on…
Hybrid beamforming for frequency-selective channels is a challenging problem as the phase shifters provide the same phase shift to all of the subcarriers. The existing approaches solely rely on the channel's frequency response and the…
Nowadays, millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems is a favorable candidate for the fifth generation (5G) cellular systems. However, a key challenge is the high power consumption imposed by its numerous…
This paper studies an energy efficient design of precoders for point-to-point multiple-input-multiple-output (MIMO) orthogonal frequency-division multiplexing (OFDM) systems. Differently from traditional approaches, the optimal power…
Massive MIMO systems are typically designed assuming linear power amplifiers (PAs). However, PAs are most energy efficient close to saturation, where non-linear distortion arises. For conventional precoders, this distortion can coherently…
A variety of hybrid analog-digital beamforming architectures have recently been proposed for massive multiple-input multiple-output (MIMO) systems to reduce energy consumption and the cost of implementation. In the analog processing network…
Massive multi-input multi-output (MIMO) can support high spectral efficiency (SE) with simple linear transceivers, and is expected to provide high energy efficiency (EE). In this paper, we analyze the EE of downlink multi-cell massive MIMO…
Hybrid precoding design can be challenging for broadband millimeter-wave (mmWave) massive MIMO due to the frequency-flat analog precoder in radio frequency (RF). Prior broadband hybrid precoding work usually focuses on fully-connected array…
This paper proposes an adaptive multi-mode transmission strategy to improve the spectral efficiency achieved in the multiple-input multiple-output (MIMO) broadcast channel with delayed and quantized channel state information. The adaptive…
In this article, we present a new approach to optimizing the energy efficiency of the cost-efficiency of quantized hybrid pre-encoding (HP) design. We present effective alternating minimization algorithms (AMA) based on the zero gradient…
This work investigates the downlink performance of a multi-cell massive multiple-input multiple-output (MIMO) system that employs one-bit analog-to-digital converters (ADCs) and digital-to-analog converters (DACs) in the receiving and…
Low-resolution analog-to-digital converters (ADCs) and hybrid beamforming have emerged as efficient solutions to reduce power consumption with satisfactory spectral efficiency (SE) in massive multiple-input multiple-output (MIMO) systems.…
High power consumption and expensive hardware are two bottlenecks for practical massive multiple-input multiple-output (mMIMO) systems. One promising solution is to employ low-resolution analog-to-digital converters (ADCs) and…