Related papers: Millimeter-Wave Beamformed Full-dimensional MIMO C…
In this paper, a channel estimator for wideband millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems with hybrid architectures and low-resolution analog-to-digital converters (ADCs) is proposed. To account for the…
Fifth generation (5G) wireless networks are expected to utilize wide bandwidths available at millimeter wave (mmWave) frequencies for enhancing system throughput. However, the unfavorable channel conditions of mmWave links, e.g., higher…
This paper proposes a deep learning-based channel estimation method for multi-cell interference-limited massive MIMO systems, in which base stations equipped with a large number of antennas serve multiple single-antenna users. The proposed…
This paper focuses on channel estimation in single-user and multi-user MIMO systems with multi-antenna base stations equipped with 1-bit spatial sigma-delta analog-to-digital converters (ADCs). A careful selection of the quantization…
To satisfy the capacity requirements of future mobile systems, under-utilized millimeter wave frequencies can be efficiently exploited by employing massive MIMO technology with highly directive beamforming. Hybrid analog-digital beamforming…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
Millimeter wave (mmWave) systems will likely employ large antenna arrays at both the transmitters and receivers. A natural application of antenna arrays is simultaneous transmission to multiple users, which requires multi-user precoding at…
This paper investigates the design of analog beamforming at the receiver in millimeter-wave (mmWave) multiple-input multiple-output (MIMO) systems, aided by full digital chains featuring 1-bit ADCs. We advocate utilizing these full digital…
In this paper, a full-duplex unmanned aerial vehicle (FD-UAV) relay is employed to increase the communication capacity of millimeter-wave (mmWave) networks. Large antenna arrays are equipped at the source node (SN), destination node (DN),…
We address the problem of fast time-varying channel estimation in millimeter-wave (mmWave) MIMO systems with imperfect channel state information (CSI) and facilitate efficient channel reconstruction. Specifically, leveraging the low-rank…
Synchronization is a fundamental procedure in cellular systems whereby an UE acquires the time and frequency information required to decode the data transmitted by a BS. Due to the necessity of using large antenna arrays to obtain the…
The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…
Millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) has been regarded to be an emerging solution for the next generation of communications, in which hybrid analog and digital precoding is an important method for reducing…
This paper considers a lens antenna array-assisted millimeter wave (mmWave) multiuser multiple-input multiple-output (MU-MIMO) system. The base station's beam selection matrix and user terminals' phase-only beamformers are jointly designed…
Hybrid massive MIMO structures with lower hardware complexity and power consumption have been considered as a potential candidate for millimeter wave (mmWave) communications. Channel covariance information can be used for designing…
This paper addresses channel estimation and data equalization on frequency-selective 1-bit quantized Multiple Input-Multiple Output (MIMO) systems. No joint processing or Channel State Information is assumed at the transmitter, and…
Millimeter wave provides a promising approach for meeting the ever-growing traffic demand in next generation wireless networks. It is crucial to obtain relatively accurate channel state information so that beamforming/combining can be…
To achieve high data rates defined in 5G, the use of millimeter-waves and massive-MIMO are indispensable. To benefit from these technologies, an accurate estimation of the channel parameters is crucial. We propose a novel two-stage…
Massive MIMO is a variant of multiuser MIMO, where the number of antennas $M$ at the base-station is large, and generally much larger than the number of spatially multiplexed data streams to/from the users. It has been observed that in many…
Communication at millimeter wave (mmWave) bands is expected to become a key ingredient of next generation (5G) wireless networks. Effective mmWave communications require fast and reliable methods for beamforming at both the User Equipment…