Related papers: Passive control of viscous flow via elastic snap-t…
Motivated by problems arising in the pneumatic actuation of controllers for micro-electromechanical systems (MEMS), labs-on-a-chip or biomimetic soft robots, and the study of microrheology of both gases and soft solids, we analyze the…
The dynamic shape relaxation of the two-layer-vesicle is calculated. In additional to the undulation relaxation where the two bilayers move in the same direction, the squeezing mode appears when the gap between the two bilayers is small. At…
Forcing dense suspensions of non-cohesive particles through constrictions might either result in a continuous flow, an intermittent one, or indefinite interruption of flow, i.e., a clog. While one of the most important (and obvious)…
A forward-facing aerospike have been identified as a passive flow control device for enhancing the aerodynamic efficiency and reducing the heat transfer in high-speed flows. In addition, it has been reported that the presence of a spike…
In this paper, we systematically study the dynamic snap-through behavior of a pre-deformed elastic ribbon by combining theoretical analysis, discrete numerical simulations, and experiments. By rotating one of its clamped ends with…
We characterize the flow of a viscous suspension in an inclined channel where the flow is maintained in a steady state under the competing influences of gravity and an applied pressure drop. The basic model relies on a diffusive-flux…
The viscous fingering instability, which forms when a less-viscous fluid invades a more-viscous one within a confined geometry, is an iconic system for studying pattern formation. For both miscible and immiscible fluid pairs the growth…
Dynamics of a single vesicle under shear flow between two parallel plates is studied using two-dimensional lattice-Boltzmann simulations. We first present how we adapted the lattice-Boltzmann method to simulate vesicle dynamics, using an…
In this paper we analyze the transport of passive tracers by deterministic stationary incompressible flows which can be decomposed over an infinite number of spatial scales without separation between them. It appears that a low order…
Compared to isotropic liquids, orientational order of nematic liquid crystals makes their rheological properties more involved, and thus requires fine control of the flow parameters to govern the orientational patterns. In microfluidic…
Direct numerical simulations are used to elucidate the interplay of wettability and fluid viscosities on immiscible fluid displacements in a heterogeneous porous medium.We classify the flow regimes based using qualitative and quantitative…
The deformation of an elastic micro-capsule in an infinite shear flow is studied numerically using a spectral method. The shape of the capsule and the hydrodynamic flow field are expanded into smooth basis functions. Analytic expressions…
A commonplace view of pressure-driven turbulence in pipes and channels is as "cascades" of streamwise momentum toward the viscous layer at the wall. We present in this paper an alternative picture of these flows as "inverse cascades" of…
Flow control is of interest in many open and wall-bounded shear flows in order to reduce drag or to avoid sudden large fluctuations that may lead to material failure. An established means of control is the application of suction through a…
The lack of a simple operable method for longitudinal dynamic self-assembly of particles in a microchannel is one of the main problems in applying this technology to a wide range of researches, such as biomedical engineering, material…
An electrohydrodynamic numerical model is used to explore the electrospray emission behavior of both moderate and high electrical conductivity liquids under electrospray conditions. The Volume-of-Fluid method, incorporating a…
The translation and shape deformations of a passive viscous Newtonian droplet immersed in an active nematic liquid crystal under circular confinement are analyzed using a linear stability analysis. We focus on the case of a sharply aligned…
We propose a control approach for a class of nonlinear mechanical systems to stabilize the system under study while ensuring that the oscillations of the transient response are reduced. The approach is twofold: (i) we apply our technique…
Flows of particles through bottlenecks are ubiquitous in nature and industry, involving both dry granular materials and suspensions. However, practical limitations of conventional experimental setups hinder the full understanding of these…
The rheology of pressure-driven flows of two-dimensional dense monodisperse emulsions in neutral wetting microchannels is investigated by means of mesoscopic lattice simulations, capable of handling large collections of droplets, in the…