Related papers: Multipair Massive MIMO Two-Way Full-Duplex Relay S…
In this paper, we investigate signal detection in multiple-input-multiple-output (MIMO) communication systems with hardware impairments, such as power amplifier nonlinearity and in-phase/quadrature imbalance. To deal with the complex…
Multiple-input/multiple-output (MIMO) systems promise enormous capacity increase and are being considered as one of the key technologies for future wireless networks. However, the decrease in capacity due to the presence of interferers in…
Movable antennas represent an emerging field in telecommunication research and a potential approach to achieving higher data rates in multiple-input multiple-output (MIMO) communications when the total number of antennas is limited. Most…
In this paper, a spatial multiplexing multiple-input multiple-output (MIMO) system when hardware along with RF imperfections occur during the communication setup is analytically investigated. More specifically, the scenario of hardware…
In-band full-duplex transmission allows a relay station to theoretically double its spectral efficiency by simultaneously receiving and transmitting in the same frequency band, when compared to the traditional half-duplex or out-of-band…
The problem of minimizing the total power consumption while satisfying different quality-of-service (QoS) requirements in a two-hop multiple-input multiple-output network with a single non-regenerative relay is considered. As shown by Y.…
Massive multiple-input multiple-output (MIMO) avails of simple transceiver design which can tackle many drawbacks of relay systems in terms of complicated signal processing, latency, and noise amplification. However, the cost and circuit…
We consider two-way amplify and forward relaying, where multiple full-duplex user pairs exchange information via a shared full-duplex massive multiple-input multiple-output (MIMO) relay. Most of the previous massive MIMO relaying works…
Robust transceiver design against unresolvable system uncertainties is of crucial importance for reliable communication. For instance, full-duplex communication suffers from such uncertainties when canceling the self-interference, since the…
Robust transceiver design against unresolvable system uncertainties is of crucial importance for reliable communication. For instance, full-duplex communication suffers from such uncertainties when canceling the self-interference, since…
In this paper, we consider a dual-hop Multiple Input Multiple Output (MIMO) relay wireless network, in which a source-destination pair both equipped with multiple antennas communicates through a large number of half-duplex…
In Part II of this two-part paper, a sum-rate-maximizing power allocation with minimum power consumption is found for multiple-input multiple-output (MIMO) decode-and-forward (DF) two-way relaying (TWR) in a network optimization scenario.…
Multiple-input multiple-output (MIMO) millimeter wave (mmWave) systems are vulnerable to hardware impairments due to operating at high frequencies and employing a large number of radio- frequency (RF) hardware components. In particular,…
To keep the hardware costs of future communications systems manageable, the use of low-cost hardware components is desirable. This is particularly true for the emerging massive multiple-input multiple-output (MIMO) systems which equip base…
The high spectral efficiency of massive MIMO (Multiple Input Multiple Output) is mainly achieved through the exploitation of spatial multiplexing, i.e. by using a high number of MIMO layers that are applied simultaneously to many users. The…
A multiple input multiple output (MIMO) two-way relay channel is considered, where two sources want to exchange messages with each other using multiple relay nodes, and both the sources and relay nodes are equipped with multiple antennas.…
We present a unified model for connected antenna arrays with a large number of tightly integrated (i.e., coupled) antennas in a compact space within the context of massive multiple-input multiple-output (MIMO) communication. We refer to…
To deal with the ever increasing data rate demand in wireless systems, suitable backhaul solutions have to be found. One option is to use LOS MIMO systems at mmWave frequencies, as high bandwidths and spectral efficiencies will be able to…
This paper deals with the problem of jointly designing the source precoder, the relaying matrices, and the destination equalizer in a multiple-relay amplify-and-forward (AF) cooperative multiple-input multiple-output (MIMO) wireless…
Reconfigurable intelligent surface (RIS) has been anticipated to be a novel cost-effective technology to improve the performance of future wireless systems. In this paper, we investigate a practical RIS-aided multiple-input-multiple-output…