Related papers: Study of Joint MSINR and Relay Selection Algorithm…

This work presents joint minimum mean-square error (MMSE) consensus algorithm and relay selection algorithms for distributed beamforming. We propose joint MMSE consensus relay and selection schemes with a total power constraint and local…

In this paper, system design for the multi-input multi-output (MIMO) relay broadcast channel with individual signal-to-interference-plus-noise ratio (SINR) constraints at the mobile stations (MS) is considered. By exploring the structure of…

We show that the performance of relay selection can be improved by employing relays with buffers. Under the idealized assumption that no buffer is full or empty, the best source-relay and the best relay-destination channels can be…

We consider joint beamforming and stream allocation to maximize the weighted sum rate (WSR) for non-coherent joint transmission (NCJT) in user-centric cell-free MIMO networks, where distributed access points (APs) are organized in clusters…

In this paper, multi-stream transmission in interference networks aided by multiple amplify-and-forward (AF) relays in the presence of direct links is considered. The objective is to minimize the sum power of transmitters and relays by…

It is well-known that the problem of finding the optimal beamformers in massive multiple-input multiple-output (MIMO) networks is challenging because of its non-convexity, and conventional optimization based algorithms suffer from high…

The problem of joint design of transmit waveforms and receive filters is desirable in many application scenarios of multiple-input multiple-output (MIMO) radar systems. In this paper, the joint design problem is investigated under the…

We propose a greedy minimum mean squared error (MMSE)-based antenna selection algorithm for amplify-and-forward (AF) multiple-input multiple-output (MIMO) relay systems. Assuming equal-power allocation across the multi-stream data, we…

Harvesting energy from the radio-frequency (RF) signal is an exciting solution to replenish energy in energy-constrained wireless networks. In this paper, an amplify-and-forward (AF) based wireless relay network is considered, where the…

This paper considers several linear beamformer design paradigms for multiuser time-invariant multiple-input multiple-output interference channels. Notably, interference alignment and sum-rate based algorithms such as the maximum…

Reconfigurable intelligent Surfaces (RIS) and half-duplex decoded and forwarded (DF) relays can collaborate to optimize wireless signal propagation in communication systems. Users typically have different rate demands and are clustered into…

Cooperative relays improve reliability and coverage in wireless networks by providing multiple paths for data transmission. Relaying will play an essential role in vehicular networks at higher frequency bands, where mobility and frequent…

The paper considers sparse array design for receive beamforming achieving maximum signal-to-interference plus noise ratio (MaxSINR) for both single point source and multiple point sources, operating in an interference active environment.…

In this paper, we investigate a multiuser relay system with simultaneous wireless information and power transfer. Assuming that both base station (BS) and relay station (RS) are equipped with multiple antennas, this work studies the joint…

While millimeter wave (mmWave) communications promise high data rates, their sensitivity to blockage and severe signal attenuation presents challenges in their deployment in urban settings. To overcome these effects, we consider a…

To deal with the explosive growth of mobile traffic, millimeter-wave (mmWave) communications with abundant bandwidth resources have been applied to vehicular networks. As mmWave signal is sensitive to blockage, we introduce the unmanned…

We propose a joint discrete stochastic optimization based transmit diversity selection (TDS) and relay selection (RS) algorithm for decode-and-forward (DF), cooperative MIMO systems with a non-negligible direct path. TDS and RS are…

Simultaneous operation of all sensors in a large-scale sensor network is power-consuming and computationally expensive. Hence, it is desirable to select fewer sensors. A greedy algorithm is widely used for sensor selection in homogeneous…

In this paper, we consider a reconfigurable intelligent surface (RIS)-assisted two-way relay network, in which two users exchange information through the base station (BS) with the help of an RIS. By jointly designing the phase shifts at…

We investigate the problem of network utility maximization in multiple gateways wireless mesh networks by considering Signal to Interference plus Noise Ratio (SINR) as the interference model. The aim is a cross layer design that considers…