Related papers: Photonic Hybrid Precoding for Millimeter Wave RoF …
Hybrid analog-digital precoding is a key millimeter wave access technology, where an antenna array with reduced number of radio frequency (RF) chains is used with an RF precoding matrix to increase antenna gain at a reasonable cost.…
Millimeter wave (mmWave) cellular systems will enable gigabit-per-second data rates thanks to the large bandwidth available at mmWave frequencies. To realize sufficient link margin, mmWave systems will employ directional beamforming with…
In this paper, we propose a feedback-efficient hybrid precoding framework for wideband millimeter-wave (mmWave) multiple-input multiple-output orthogonal frequency-division multiplexing (MIMO-OFDM) systems. To mitigate the high cost of…
In millimeter-wave (mmWave) MIMO systems, while a hybrid digital/analog precoding structure offers the potential to increase the achievable rate, it also faces the challenge of the need of a low-complexity design. In specific, the hybrid…
Millimeter-wave (mmWave) technology is a crucial enabler for next-generation networks because it offers substantially greater available bandwidth. mmWave multiple-input multiple-output (MIMO) systems cannot rely solely on fully digital…
Hybrid precoding design can be challenging for broadband millimeter-wave (mmWave) massive MIMO due to the frequency-flat analog precoder in radio frequency (RF). Prior broadband hybrid precoding work usually focuses on fully-connected array…
Millimeter wave (mmWave) communication is a promising solution for coping with the ever-increasing mobile data traffic because of its large bandwidth. To enable a sufficient link margin, a large antenna array employing directional…
Hybrid precoding is a promising technique for mmWave massive MIMO systems, as it can considerably reduce the number of required radio-frequency (RF) chains without obvious performance loss. However, most of the existing hybrid precoding…
Hybrid analog/digital precoding allows millimeter wave MIMO systems to leverage large antenna array gains while permitting low cost and power consumption hardware. Most prior work has focused on hybrid precoding for narrow-band mmWave…
This paper studies energy-efficient hybrid beamforming architectures and its algorithm design in millimeter-wave communication systems, aiming to address the challenges faced by existing hybrid beamforming due to low hardware flexibility…
Millimeter-wave (mmWave) communication is considered as an indispensable technique for the next-generation backhaul/fronthaul network thanks to its large transmission bandwidth. Especially for heterogeneous network (HetNet), the mmWave…
In this letter, we aim to design a robust hybrid precoder and combiner against beam misalignment in millimeter-wave (mmWave) communication systems. We consider the inclusion of the `error statistics' into the precoder and combiner design,…
In millimeter wave (mmWave) systems, antenna architecture limitations make it difficult to apply conventional fully digital precoding techniques but call for low cost analog radio-frequency (RF) and digital baseband hybrid precoding…
The high energy consumption of massive multi-input multi-out (MIMO) system has become a prominent problem in the millimeter wave(mm-Wave) communication scenario. The hybrid precoding technology greatly reduces the number of radio…
Configuring hybrid precoders and combiners is a major challenge to deploy practical mmWave communication systems. Prior work addresses the problem of designing hybrid precoders and combiner, yet focusing on finding solutions under a total…
In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…
Hybrid beamforming is key to achieving energy-efficient 5G wireless networks equipped with massive amount of antennas. Low-resolution data converters bring yet another degree of freedom to energy efficiency for the state-of-the-art 5G…
In this paper, we develop a low-complexity channel estimation for hybrid millimeter wave (mmWave) systems, where the number of radio frequency (RF) chains is much less than the number of antennas equipped at each transceiver. The proposed…
Hybrid precoding can significantly reduce the number of required radio frequency (RF) chains and relieve the huge energy consumption in mmWave massive MIMO systems, thus attracting much interests from academic and industry. However, most…
In the context of integrated sensing and communication (ISAC), a full-duplex (FD) transceiver can operate as a monostatic radar while maintaining communication capabilities. This paper investigates the design of precoders and combiners for…