Related papers: Joint Uplink and Downlink Coverage Analysis of Cel…
Many of the devices used in Internet-of-Things (IoT) applications are energy-limited, and thus supplying energy while maintaining seamless connectivity for IoT devices is of considerable importance. In this context, we propose a…
In this paper, we consider an energy-harvesting (EH) relay system consisting of a source, a destination, and multiple EH decode-and-forward (DF) relays that can harvest the energy from their received radio signals. A power-splitting ratio…
In this paper, downlink secure transmission in simultaneous information and power transfer (SWIPT) system enabled with massive multiple-input multiple-output (MIMO) is studied. A base station (BS) with a large number of antennas transmits…
Many future Internet of Things (IoT) applications are expected to rely heavily on reconfigurable intelligent surface (RIS)-aided unmanned aerial vehicles (UAVs). However, the endurance of such systems is constrained by the limited onboard…
The Internet of Things (IoT) is going to be a few of the most influential and critical role spectators in the post-5G and 6G wireless networking paradigm because IoT is being deployed in a variety of applications and services such as smart…
Providing seamless connection to a large number of devices is one of the biggest challenges for the Internet of Things (IoT) networks. Using a drone as an aerial base station (ABS) to provide coverage to devices or users on ground is…
Ambient Internet of Things (AIoT), recently standardized by the 3rd Generation Partnership Project (3GPP), demands a low-power wide-area communication solution that operates several orders of magnitude below the power requirements of…
In this paper, we investigate and analyze energy recycling for a reconfigurable intelligent surface (RIS)-aided wireless-powered communication network. As opposed to the existing works where the energy harvested by Internet of things (IoT)…
The problem of simultaneously optimizing the information rate and the harvested power in a reconfigurable intelligent surface (RIS)-aided multiple-input single-output downlink wireless network with simultaneous wireless information and…
We study internet of things (IoT) systems supported by cell-free (CF) massive MIMO (mMIMO) with optimal linear channel estimation. For the uplink, we consider optimal linear MIMO receiver and obtain an uplink SINR approximation involving…
The use of satellites to provide ubiquitous coverage and connectivity for densely deployed Internet of Things (IoT) networks is expected to be a reality in emerging 6G networks. Yet the low battery capacity of IoT nodes constitutes a…
The emerging Internet of Things (IoT)-driven ultra-dense small cell networks (UD-SCNs) will need to combat a variety of challenges. On one hand, massive number of devices sharing the limited wireless resources will render centralized…
The tradeoff between cost of the access network and quality of offered service to IoT devices, in terms of reliability and durability of communications, is investigated. We first develop analytical tools for reliability evaluation in…
In this paper, we present a detailed analysis of the coverage and spectral efficiency of a downlink cellular network. Rather than relying on the first order statistics of received signal-to-interference-ratio (SIR) such as coverage…
Spectrum scarcity has surfaced as a prominent concern in wireless radio communications with the emergence of new technologies over the past few years. As a result, there is growing need for better understanding of the spectrum occupancy…
The separate receiver architecture with a time- or power-splitting mode, widely used for simultaneous wireless information and power transfer (SWIPT), has a major drawback: Energy-intensive local oscillators and mixers need to be installed…
The paper studies optimal sensor selection for source estimation in energy harvesting Internet of Things (IoT) networks. Specifically, the focus is on the selection of the sensor locations which minimizes the estimation error at a fusion…
We consider the joint design of transmit beamforming and receive signal-splitting ratios in the downlink of a wireless network with simultaneous radio-frequency (RF) information and energy transfer. Under constraints on the…
The downlink of a single cell base station (BS) equipped with large-scale multiple-input multiple-output (MIMO) system is investigated in this paper. As the number of antennas at the base station becomes large, the power consumed at the RF…
Internet-of-things (IoT) architectures connecting a massive number of heterogeneous devices need energy efficient, low hardware complexity, low cost, simple and secure mechanisms to realize communication among devices. One of the emerging…