Related papers: Wireless Energy Beamforming using Received Signal …
A new line of research on communications and signals design for Wireless Power Transfer (WPT) has recently emerged in the communication literature. Promising signal strategies to maximize the power transfer efficiency of WPT rely on…
Accurate, real-time wireless signal prediction is essential for next-generation networks. However, existing vision-based frameworks often rely on computationally intensive models and are also sensitive to environmental interference. To…
Radio frequency (RF) wireless power transfer (WPT) is a promising technology to seamlessly charge low-power devices, but its low end-to-end power transfer efficiency remains a critical challenge. To address the latter, low-cost…
In a typical multi-standard military communication receiver, fast and reliable spectrum sensing unit is required to extract the information of multiple channels (frequency bands) present in a wideband input signal. In this paper, an energy…
In this paper, we investigate the design of energy-efficient beamforming for an ISAC system, where the transmitted waveform is optimized for joint multi-user communication and target estimation simultaneously. We aim to maximize the system…
In this paper, we study the average throughput performance of energy beamforming in a multi-antenna wireless-powered communication network (WPCN). The considered network consists of one hybrid access-point (AP) with multiple antennas and a…
The advance in RF energy transfer and harvesting technique over the past decade has enabled wireless energy replenishment for electronic devices, which is deemed as a promising alternative to address the energy bottleneck of conventional…
This paper explores a multi-antenna dual-functional radio frequency (RF) wireless power transfer (WPT) and radar system to charge multiple unresponsive devices. We formulate a beamforming problem to maximize the minimum received power at…
This paper addresses a drawback of massive multiple-input multiple-output Maximum Ratio Transmission beamforming. In some propagation conditions, when the base station serves the same target user equipment for a long period, it reduces the…
Distributed beamforming is a key enabler to provide power wirelessly to a massive amount of energy-neutral devices (ENDs). However, without prior information and fully depleted ENDs, initially powering these devices efficiently is an open…
This paper maximizes the achievable throughput of a relay-assisted wirelessly powered communications system, where an energy constrained source, helped by an energy constrained relay and both powered by a dedicated power beacon (PB),…
Wireless Energy Transfer (WET) is emerging as a potential solution for powering small energy-efficient devices. We propose strategies that use multiple antennas at a power station, which wirelessly charges a large set of single-antenna…
Radio Frequency Identification (RFID) and implantable biomedical devices need efficient power and data transfer with very low profile antennas. We propose a low profile electrically small antenna for near-field wireless power and data…
Utilizing intelligent reflecting surface (IRS) was proven to be efficient in improving the energy efficiency for wireless networks. In this paper, we investigate the passive beamforming and channel estimation for IRS assisted wireless…
This paper studies an intelligent reflecting surface (IRS)-assisted multiuser multiple-input single-output (MISO) simultaneous wireless information and power transfer (SWIPT) system. In this system, a multi-antenna access point (AP) uses…
Active reconfigurable intelligent surface (RIS) emerges as an effective technique to resist the double-fading attenuation of passive RIS. By embedding with power harvesting function, it further evolves to zero-power active RIS, which can…
This paper presents the concept, design, channel modeling, beamforming algorithm development, prototype fabrication, and experimental measurement of an electromagnetically reconfigurable fluid antenna system (ER-FAS), in which each FAS…
This paper studies a multi-user multiple-input single-output (MISO) downlink system for simultaneous wireless information and power transfer (SWIPT), in which a set of single-antenna mobile stations (MSs) receive information and energy…
In this paper, we propose beamforming schemes to simultaneously transmit data securely to multiple information receivers (IRs) while transferring power wirelessly to multiple energy-harvesting receivers (ERs). Taking into account the…
This letter investigates the artificial noise aided beamforming design for secure simultaneous wireless information and power transfer (SWIPT) in a two-tier downlink heterogeneous network, where one femtocell is overlaid with one macrocell…