Related papers: Frequency-domain Compressive Channel Estimation fo…
Low overhead channel estimation based on compressive sensing (CS) has been widely investigated for hybrid wideband millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems. The channel sparsifying dictionaries used in prior…
Millimeter-wave massive MIMO with lens antenna array can considerably reduce the number of required radio-frequency (RF) chains by beam selection. However, beam selection requires the base station to acquire the accurate information of…
Massive MIMO is a variant of multiuser MIMO where the number of base-station antennas $M$ is very large (typically 100), and generally much larger than the number of spatially multiplexed data streams (typically 10). Unfortunately, the…
Millimeter-wave (mmWave) massive MIMO used for access and backhaul in ultra-dense network (UDN) has been considered as the promising 5G technique. We consider such an heterogeneous network (HetNet) that ultra-dense small base stations (BSs)…
As a key enabling technology for 5G wireless, millimeter wave (mmWave) communication motivates the utilization of large-scale antenna arrays for achieving highly directional beamforming. However, the high cost and power consumption of RF…
Hybrid analog/digital precoding in millimeter-wave (mmWave) multi-input multi-ouput (MIMO) systems is capable of achieving the near-optimal full-digital performance at reduced hardware cost and power consumption compared to its full-RF…
Millimeter-wave (mm-Wave) cellular systems are a promising option for a very high data rate communication because of the large bandwidth available at mm-Wave frequencies. Due to the large path-loss exponent in the mm-Wave range of the…
Compressive sensing is a promising solution for the channel estimation in multiple-input multiple-output (MIMO) systems with large antenna arrays and constrained hardware. Utilizing site-specific channel data from real-world systems, deep…
Fast millimeter wave (mmWave) channel estimation techniques based on compressed sensing (CS) suffer from low signal-to-noise ratio (SNR) in the channel measurements, due to the use of wide beams. To address this problem, we develop an…
This paper considers the problem of pilot design for compressive multiple-input multiple-output (MIMO) channel estimation. In particular, we are interested in estimating the channels for multiple transmitters simultaneously when the pilot…
This paper investigates downlink channel estimation in frequency-division duplex (FDD)-based massive multiple-input multiple-output (MIMO) systems. To reduce the overhead of downlink channel estimation and uplink feedback in FDD systems,…
Recently, a switch-based hybrid massive MIMO structure that aims to reduce the hardware complexity and power consumption has been proposed as a potential candidate for millimeter wave (mmWave) communications. Exploiting the sparse nature of…
This letter presents a low-complexity hybrid precoding framework for multiuser multiple-input multiple-output (MIMO) systems by leveraging a low-dimensional subspace property. Under the low-dimensional subspace perspective, we first…
The tremendous bandwidth available in the millimeter wave (mmW) frequencies between 30 and 300 GHz have made these bands an attractive candidate for next-generation cellular systems. However, reliable communication at these frequencies…
Given the high degree of computational complexity of the channel estimation technique based on the conventional one-dimensional (1-D) compressive sensing (CS) framework employed in the hybrid beamforming architecture, this study proposes…
Millimeter wave (mmWave) communication is a promising solution for coping with the ever-increasing mobile data traffic because of its large bandwidth. To enable a sufficient link margin, a large antenna array employing directional…
Integrating large intelligent reflecting surfaces (IRS) into millimeter-wave (mmWave) massive multi-input-multi-ouput (MIMO) has been a promising approach for improved coverage and throughput. Most existing work assumes the ideal channel…
Classical linear statistical models, like the first-order auto-regressive (AR) model, are commonly used as channel model in high-mobility scenarios. However, compared to sub-6G, the effect of Doppler frequency shifts is more significant at…
In this paper, we tackle channel estimation in millimeter-wave hybrid multiple-input multiple-output systems by considering off-grid effects. In particular, we assume that spatial parameters can take any value in the angular domain, and…
Hybrid analog/digital precoding is a promising technology to cut down hardware cost in massive multi-input multi-output (MIMO) systems at millimeter wave frequencies. In this letter, we propose a joint beam selection scheme for analog…