Related papers: Iterative Hybrid Precoder and Combiner Design for …
In this paper, we focus on the design of the hybrid analog/digital precoding in millimeter wave multiple-input multiple-output (MIMO) systems. To reduce the feedback overhead, we propose two non-uniform quantization (NUQ) codebook based…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
This paper studies a multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) networked integrated sensing and communication (ISAC) system, in which multiple base stations (BSs) perform beam tracking to…
This paper proposes a joint optimization of pilot subcarrier allocation and non-orthogonal sequence for multiple-input-multiple-output (MIMO)-orthogonal frequency-division multiplexing (OFDM) systems under compressed sensing (CS)-based…
Orthogonal frequency division multiplexing (OFDM) has proven itself as an effective multi-carrier digital communication technique. In recent years the interest in optical OFDM has grown significantly, due to its spectral efficiency and…
Filter bank-based multicarrier (FBMC) systems are currently being considered as a prevalent candidate for replacing the long established cyclic prefix (CP)-based orthogonal frequency division multiplexing (CP-OFDM) in the physical layer of…
The high energy consumption of massive multi-input multi-out (MIMO) system has become a prominent problem in the millimeter wave(mm-Wave) communication scenario. The hybrid precoding technology greatly reduces the number of radio…
Orthogonal frequency division multiplexing (OFDM) has been recently recognized as inadequate to meet the increased requirements of the next generation of communication systems. A number of alternative modulation solutions, based on the use…
Iterative information processing, either based on heuristics or analytical frameworks, has been shown to be a very powerful tool for the design of efficient, yet feasible, wireless receiver architectures. Within this context, algorithms…
Machine learning (ML) can be used in various ways to improve multi-user multiple-input multiple-output (MU-MIMO) receive processing. Typical approaches either augment a single processing step, such as symbol detection, or replace multiple…
As a new type of multicarrier (MC) scheme built upon the recently discovered delay-Doppler domain orthogonal pulse (DDOP), orthogonal delay-Doppler division multiplexing (ODDM) aims to address the challenges of waveform design in linear…
The design of precoding plays a crucial role in achieving a high downlink sum-rate in multiuser multiple-input multiple-output (MIMO) orthogonal frequency-division multiplexing (OFDM) systems. In this correspondence, we propose a deep…
Due to the flexibility in spectrum shaping, orthogonal frequency division multiplexing (OFDM) is a promising technique for dynamic spectrum access. However, the out-of-band (OOB) power radiation of OFDM introduces significant interference…
This paper attempts to jointly optimize the hybrid precoding (HP) and intelligent reflecting surfaces (IRS) beamforming matrices in a multi-IRS-aided mmWave communication network, utilizing the Alamouti scheme at the base station (BS).…
Multiple-input multiple-output (MIMO) technology applied with orthogonal frequency division multiplexing (OFDM) is considered as the ultimate solution to increase channel capacity without any additional spectral resources. At the receiver…
Hybrid analog/digital MIMO architectures were recently proposed as an alternative for fully-digitalprecoding in millimeter wave (mmWave) wireless communication systems. This is motivated by the possible reduction in the number of RF chains…
Massive MIMO is a variant of multiuser MIMO where the number of base-station antennas $M$ is very large (typically 100), and generally much larger than the number of spatially multiplexed data streams (typically 10). Unfortunately, the…
This letter investigates the hybrid analog and digital beamforming (HBF) design for multiuser millimeter wave (mmWave) communication systems based on the minimum mean square error (MMSE) criterion. Using the alternating minimization method,…
This letter considers the transceiver design in frequency division duplex (FDD) massive multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems for high-quality data transmission. We propose a novel…
Hybrid beamforming has evolved as a promising technology that offers the balance between system performance and design complexity in mmWave MIMO systems. Existing hybrid beamforming methods either impose unit-modulus constraints or a…