Related papers: Waveform Design for Wireless Power Transfer with L…
This paper studies a cognitive or secondary multi-antenna wireless power transfer (WPT) system over a multi-carrier channel, which shares the same spectrum with a primary wireless information transfer (WIT) system that employs adaptive…
Radio frequency (RF) wireless power transfer (WPT) is a promising technology for charging the Internet of Things. Practical RF-WPT systems usually require energy beamforming (EB), which can compensate for the severe propagation loss by…
This letter studies a multi-antenna wireless powered communication (WPC) system with co-channel energy and information transfer, where a wireless device (WD), powered up by wireless energy transfer (WET) from an energy transmitter (ET),…
This paper proposes a chaotic waveform-based multi-antenna receiver design for simultaneous wireless information and power transfer (SWIPT). Particularly, we present a differential chaos shift keying (DCSK)-based SWIPT multiantenna receiver…
This paper proposes a novel channel estimation method and a cluster-based opportunistic scheduling policy, for a wireless energy transfer (WET) system consisting of multiple low-complex energy receivers (ERs) with limited processing…
Classical beamforming techniques rely on highly linear transmitters and receivers to allow phase-coherent combining at the transmitter and receiver. The transmitter uses beamforming to steer signal power towards the receiver, and the…
We study the beamforming design for multiuser systems with simultaneous wireless information and power transfer (SWIPT). Employing a practical non-linear energy harvesting (EH) model, the design is formulated as a non-convex optimization…
Far-field Wireless Power Transfer (WPT) has emerged as a potential power source for the Internet of Things (IoT) and Wireless Sensor Network (WSN).The expansion of the power transfer range is one of the key challenges to make the technology…
This paper shows that wirelessly powered backscatter communications is subject to a fundamental tradeoff between the harvested energy at the tag and the reliability of the backscatter communication, measured in terms of SNR at the reader.…
We study radio-frequency (RF) wireless power transfer (WPT) using a digital radio transmitter for applications where alternative analog transmit circuits are impractical. An important paramter for assessing the viability of an RF WPT system…
This paper studies a general multi-user wireless powered interference channel (IFC) under the harvest-then-transmit protocol, where the communication in channel coherence time consists of two phases, namely wireless energy transfer (WET)…
This letter investigates a multiple-input multiple-output (MIMO) wireless power transfer (WPT) system under practical non-liner energy harvesting (EH) models. We propose a new generic energy receiver (ER) architecture consisting of $N$…
Wireless power transfer (WPT) is an emerging paradigm that will enable using wireless to its full potential in future networks, not only to convey information but also to deliver energy. Such networks will enable trillions of future…
In this paper, we study multiple-input multiple-output (MIMO) wireless power transfer (WPT) systems, where the energy harvester (EH) node is equipped with multiple nonlinear rectennas. We characterize the optimal transmit strategy by the…
This paper studies the transmit energy beamforming in a multi-antenna wireless power transfer (WPT) system, in which an access point (AP) equipped with a uniform linear array (ULA) sends radio signals to wirelessly charge multiple…
Radiative wireless power transfer (WPT) is a promising technology to provide cost-effective and real-time power supplies to wireless devices. Although radiative WPT shares many similar characteristics with the extensively studied wireless…
Radio frequency (RF) wireless power transfer (WPT) is a promising technology for sustainable support of massive Internet of Things (IoT). However, RF-WPT systems are characterized by low efficiency due to channel attenuation, which can be…
A near-field simultaneous wireless information and power transfer (SWIPT) network is investigated, where the hybrid beamforming architecture is employed at the base station (BS) for information transmission while charging energy harvesting…
This paper analyzes the communication between two energy harvesting wireless sensor nodes. The nodes use automatic repeat request and forward error correction mechanism for the error control. The random nature of available energy and…
Integrated data and energy transfer (IDET) has been of fundamental importance for providing both wireless data transfer (WDT) and wireless energy transfer (WET) services towards low-power devices. Fluid antenna (FA) is capable of exploiting…