Related papers: Strain Mode of General Flow: Characterization and …
Mixing fronts form when fluids with different chemical compositions are brought into contact. They influence a large range of biogeochemical processes in hydrological systems. An important mechanism governing mixing rates in such fronts is…
Wave propagation in architectured materials, or materials with microstructure, is known to be dependent on the ratio between the wavelength and a characteristic size of the microstructure. Indeed, when this ratio decreases (i.e. when the…
Describing and measuring the elastic properties of cellular materials such as honeycombs and foams can be a difficult problem when the cell structure is disordered. This paper suggests that tracking the flow of forces through the material…
Failure and flow of amorphous materials are central to various phenomena including earthquakes and landslides. There is accumulating evidence that the yielding transition between a flowing and an arrested phase is a critical phenomenon, but…
Accurate and robust models for the pressure strain correlation are an essential component for the success of Reynolds Stress Models in turbulent flow simulations. However replicating the non-local action of pressure using only local tensors…
Branching is an essential element of streamer discharge dynamics but today it is understood only qualitatively. The variability and irregularity observed in branched streamer trees suggest that stochastic terms are relevant for the…
The entrainment of underlying erodible material by geophysical flows can significantly boost the flowing mass and increase the final deposition extent. The particle size of both the flowing material and the erodible substrate influence the…
The possible ``phase diagrams'' for shear-induced phase transitions between two phases are collected. We consider shear-thickening and shear-thinning fluids, under conditions of both common strain rate and common stress in the two phases,…
We investigate the possibility that the spatial dependency of stress in generalized Newtonian flow systems is a function of the applied pressure field and the conduit geometry but not of the fluid rheology. This possibility is well…
While confinement is understood to increase the power and thrust coefficients of cross-flow turbines, how the optimal rotor geometry changes with the blockage ratio -- defined as the ratio between the array projected area and the channel…
Liquid wetting of a surface is omnipresent in nature and the advance of micro-fabrication and assembly techniques in recent years offers increasing ability to control this phenomenon. Here, we identify how surface roughness influences the…
The plastic flow of a polycrystal is analyzed assuming grains as fine that the rate limiting process is grain boundary sliding, and grains readily accommodate their shapes by slip to preserve spatial continuity. It is shown that thinking of…
Drawing inspiration from the lateral lines of fish, the inference of flow characteristics via surface-based data has drawn considerable attention. The current approaches often rely on analytical methods tailored exclusively for potential…
Discrete element method simulations of confined bidisperse granular shear flows elucidate the balance between diffusion and segregation that can lead to either mixed or segregated states, depending on confining pressure. Results indicate…
Accurate prediction of fracture toughness under complex loading conditions, like mixed mode I/II, is essential for reliable failure assessment. This paper aims to develop a machine learning framework for predicting fracture toughness and…
We investigate experimentally the drying of a small volume of perfectly wetting liquid on two crossed fibers. We characterize the drying dynamics for the three liquid morphologies that are encountered in this geometry: drop, column and a…
We study the evolution of a localized perturbation in a chemical system with multiple homogeneous steady states, in the presence of stirring by a fluid flow. Two distinct regimes are found as the rate of stirring is varied relative to the…
We investigate the processes that lead to the generation of mean flows in two-dimensional anelastic convection. The simple model consists of a plane layer that is rotating about an axis inclined to gravity. The results are two-fold: firstly…
Plastic deformation in solids induced by external shear stress is of huge practical interest. Presence of local crystalline order in polycrystals, consisting of many grains, distinguishes its deformation pattern from that of amorphous…
Oscillating sharp edges have been employed to achieve rapid and homogeneous mixing in microchannels using acoustic streaming. Here we use a perturbation approach to study the flow around oscillating sharp edges in a microchannel. This work…