Related papers: Determination of the thermopower of microscale sam…
We describe an AC method for the measurement of the longitudinal (Sxx) and transverse (Sxy, i.e. Nernst) thermopower of mm-size single crystal samples at low temperatures (T<1 K) and high magnetic fields (B>30 T). A low-frequency (33 mHz)…
An AC susceptometer operating in the range of 10 Hz to 100 kHz and at room temperature is designed, built, calibrated and used to characterize the magnetic behaviour of coated magnetic nanoparticles. Other weakly magnetic materials (in…
We developed a new type of AC microcalorimeter based on a modulated-bath technique for measuring the specific heat of small microgram samples in the temperature range from 30-300 K, and tested it in magnetic fields up to 14 T. The device is…
Using the strong temperature dependent resistance of a normal metal wire in proximity to a superconductor, we have been able to measure the local temperature of electrons heated by flowing a dc current in a metallic wire to within a few…
Using a new second derivative technique and thermometers which enable us to determine the local electron temperature in a mesoscopic metallic sample, we have obtained quantitative measurements of the low temperature field and temperature…
The main purpose of this work was to design, develop and construct a simple, low-cost AC susceptometer to measure large, bulk superconducting samples (up to 32 mm in diameter) in the temperature range 78-120 K. The design incorporates a…
We report measurements of thermopower oscillations $vs$ magnetic field in a diffusive Andreev interferometer. Upon the increase of the dc current applied to the heater electrodes, the amplitude of these oscillations first increases then…
We describe an alternating current method to measure the Nernst effect in superconducting thin films at low temperatures. The Nernst effect is an important tool in the understanding superconducting fluctuations and, in particular, vortex…
We report on the resistance behavior of bare-chip Cernox thermometers under pressures up to 2 GPa, generated in a piston-cylinder pressure cell. Our results clearly show that Cernox thermometers, frequently used in low-temperature…
We present a simplified, rapid, and accurate method for the measurement of the thermoelectric Thomson coefficient by the dynamical heating of a suspended wire by an alternating current. By applying a temperature gradient across the wire, we…
Superconducting circuits provide a versatile and controllable platform for studies of fundamental quantum phenomena as well as for quantum technology applications. A conventional technique to read out the state of a quantum circuit or to…
Thermal conductivity and interfacial thermal conductance play crucial roles in the design of engineering systems where temperature and thermal stress are of concerns. To date, a variety of measurement techniques are available for both bulk…
A new ac calorimeter, utilizing the Peltier effect of a thermocouple junction as an ac power source, is described. This Peltier ac calorimeter allows to measure the absolute value of heat capacity of small solid samples with sub-milligrams…
In a recent article [Phys. Rev. Applied 5, 024005 (2016)], Gibelli and coworkers proposed a method to determine the thermopower, i.e. the Seebeck coefficient, using photoluminescence measurements. The photoluminescence spectra are used to…
AC-specific heat measurements remain as the foremost thermodynamic experimental method to underpin phase transitions in tiny samples. However, its performance under combined extreme conditions of high-pressure, very low temperature and…
The generation of harmonics of the voltage response is considered when an AC current is applied through a superconducting film above T_c. It is shown that almost at all temperatures the mechanism of the temperature oscillations created by…
We discuss the low-frequency response of charge and heat transport to oscillatory voltage and temperature shifts in mesoscopic capacitors. We obtain within scattering theory generic expressions for the quantum admittances up to second order…
Anomalously large thermopower of mesoscopic normal-metal/superconductor interferometers has been investigated by Chandrasekhar et al. It was shown that, depending on the geometry of the interferometer, the thermopower is either symmetric or…
The thermopower and conductance of atomic-size metallic contacts have been simultaneously measured using a mechanically controllable break junction. For contacts approaching atomic dimensions, abrupt steps in the thermopower are observed…
Quantitative thermoelectric measurements in the mesoscopic regime require accurate knowledge of temperature, thermovoltage, and device energy scales. We consider the effect of a finite load resistance on thermovoltage measurements of…