Related papers: Performance Analysis for Time-of-Arrival Estimatio…
Device to Device (D2D) Communication is expected to be a core part of the forthcoming 5G Mobile Communication Networks as it promises improvements in energy efficiency, spectral efficiency, overall system capacity, and higher data rates…
We propose a new method to measure the system noise temperature, $T_{\rm sys}$, using a 2-bit analog-to-digital converter (ADC). The statistics of the digitized signal in a four-level quantization brings us information about the bias…
Multi-input multi-output orthogonal frequency division multiplexing (MIMO OFDM) is a key technology for mobile communication systems. However, due to the issue of high peak-to-average power ratio (PAPR), the OFDM symbols may suffer from…
Future wireless communications will rely on multiple-input multiple-output (MIMO) beamforming operating at millimeter wave (mmWave) frequency bands to deliver high data rates. To support flexible spatial processing and meet the demands of…
This paper proposes and evaluates a novel architecture for a low-power Time-to-Digital Converter with high resolution, optimized for both integration in multichannel chips and high rate operation (40 Mconversion/s/channel). This converter…
An Adaptive Nonlinear Differential Limiter (ANDL) is proposed in this paper to efficiently alleviate the impact of impulsive noise (IN) in a communication system. Unlike existing nonlinear methods, the ANDL is implemented in the analog…
Digital PID control requires a differencing operation to implement the D gain. In order to suppress the effects of noisy data, the traditional approach is to filter the data, where the frequency response of the filter is adjusted manually…
The low-resolution analog-to-digital convertor (ADC) is a promising solution to significantly reduce the power consumption of radio frequency circuits in massive multiple-input multiple-output (MIMO) systems. In this letter, we investigate…
Wireless OFDM channels can be approximated by a time varying filter with sparse time domain taps. Recent achievements in sparse signal processing such as compressed sensing have facilitated the use of sparsity in estimation, which improves…
Network-assisted full-duplex (NAFD) distributed massive multiple input multiple output (M-MIMO) enables the in-band full-duplex with existing half-duplex devices at the network level, which exceptionally improves spectral efficiency. This…
We present the development and characterization of a generic, reconfigurable, low-cost ($<$ 350 USD) software-defined digital receiver system (DRS) for temporal correlation measurements in atomic spin ensembles. We demonstrate the use of…
This paper studies networked control systems closed over noiseless digital channels. By focusing on noisy LTI plants with scalar-valued control inputs and sensor outputs, we derive an absolute lower bound on the minimal average data rate…
State of the art time automatic speech recognition (ASR) systems are becoming increasingly complex and expensive for practical applications. This paper presents the development of a high performance and low-footprint 4-bit quantized LF-MMI…
Spiking neural networks (SNNs) operating with asynchronous discrete events show higher energy efficiency with sparse computation. A popular approach for implementing deep SNNs is ANN-SNN conversion combining both efficient training of ANNs…
Target detection is an important problem in multiple-input multiple-output (MIMO) radar. Many existing target detection algorithms were proposed without taking into consideration the quantization error caused by analog-to-digital converters…
In the evaluation of quantum annealers, metrics based on ground state success rates have two major drawbacks. First, evaluation requires computation time for both quantum and classical processors that grows exponentially with problem size.…
Multiple-input multiple-output (MIMO) systems exploit spatial diversity to facilitate multi-user communications with high spectral efficiency by beamforming. As MIMO systems utilize multiple antennas and radio frequency (RF) chains, they…
Large-scale linear, time-invariant (LTI) dynamical systems are widely used to characterize complicated physical phenomena. We propose a two-stage algorithm to reduce the order of a large-scale LTI system given samples of its transfer…
Massive MIMO systems are moving toward increased numbers of radio frequency chains, higher carrier frequencies and larger bandwidths. As such, digital-to-analog converters (DACs) are becoming a bottleneck in terms of hardware complexity and…
This paper presents a dynamic predictive sampling (DPS) based analog-to-digital converter (ADC) that provides a non-uniform sampling of input analog continuous-time signals. The processing unit generates a dynamic prediction of the input…