Related papers: Performance Analysis for Channel Estimation with 1…
A channel with continuous phase modulation and 1-bit ADC with oversampling is considered. Due to oversampling, higher-order modulations yield a higher achievable rate and this work presents a method to approach this with sophisticated…
The recently introduced atomic norm minimization (ANM) framework for parameter estimation is a promising candidate towards low overhead channel estimation in wireless communications. However, previous works on ANM-based channel estimation…
This paper is concerned with channel estimation in MIMO systems with few-bit ADCs. In these systems, a linear minimum mean-squared error (MMSE) channel estimator obtained in closed-form is not an optimal solution. We first consider a deep…
In this letter, we investigate the downlink performance of massive multiple-input multiple-output (MIMO) systems where the base station is equipped with one-bit analogto-digital/digital-to-analog converters (ADC/DACs). Considering…
This paper investigated the uplink of multi-user massive multi-input multi-output (MIMO) systems with a mixed analog-to-digital converter (ADC) receiver architecture, in which some antennas are equipped with costly full-resolution ADCs and…
In a cell-free cloud radio access network (C-RAN) architecture, uplink channel estimation is carried out by a centralized baseband processing unit (BBU) connected to distributed remote radio heads (RRHs). When the RRHs have multiple…
Massive multiple-input multiple-output (MIMO) can improve the overall system performance significantly. Massive MIMO systems, however, may require a large number of radio frequency (RF) chains that could cause high cost and power…
This work considers detecting the presence of a band-limited random radio source using an antenna array featuring a low-complexity digitization process with single-bit output resolution. In contrast to high-resolution analog-to-digital…
For a massive multiple-input-multiple-output (MIMO) system using intelligent reflecting surface (IRS) equipped with radio frequency (RF) chains, the multi-channel RF chains are expensive compared to passive IRS, especially, when the…
In this paper, we analyze the ergodic rate of single transmit antenna selection (TAS) in low-resolution analog-to-digital converter (ADC) systems. Using low-resolution ADCs is a potential power-reduction solution for multiple antenna…
The uplink achievable rate of massive multiple- input-multiple-output (MIMO) systems, where the low-resolution analog-to-digital converters (ADCs) are assumed to equip at the base station (BS), is investigated in this paper. We assume that…
This paper considers training-based transmissions in massive multi-input multi-output (MIMO) systems with one-bit analog-to-digital converters (ADCs). We assume that each coherent transmission block consists of a pilot training stage and a…
The use of one-bit analog-to-digital converters (ADCs) at a receiver is a power-efficient solution for future wireless systems operating with a large signal bandwidth and/or a massive number of receive radio frequency chains. This solution,…
We study multi-user massive multiple-input single-output (MISO) systems and focus on downlink transmission, where the base station (BS) employs a large antenna array with low-cost 1-bit digital-to-analog converters (DACs). The direct…
Analog to digital converters (ADCs) act as a bridge between the analog and digital domains. Two important attributes of any ADC are sampling rate and its dynamic range. For bandlimited signals, the sampling should be above the Nyquist rate.…
Energy efficiency of fixed-rate transmissions is studied in the presence of queueing constraints and channel uncertainty. It is assumed that neither the transmitter nor the receiver has channel side information prior to transmission. The…
We analyze limited feedback in systems where a multiple-antenna transmitter sends signals to single-antenna receivers with finite-bit ADCs. If channel state information (CSI) is not available with high resolution at the transmitter and the…
Low-resolution analog-to-digital converters (ADCs) have emerged as an efficient solution for massive multiple-input multiple-output (MIMO) systems to reap high data rates with reasonable power consumption and hardware complexity. In this…
Hybrid analog-digital precoding architectures and low-resolution analog-to-digital converter (ADC) receivers are two solutions to reduce hardware cost and power consumption for millimeter wave (mmWave) multiple-input multiple-output (MIMO)…
For 5G it will be important to leverage the available millimeter wave spectrum. To achieve an approximately omni- directional coverage with a similar effective antenna aperture compared to state of the art cellular systems, an antenna array…