Related papers: Predicting changes in visual appearance of periodi…
The Bragg regime shifts when conventional materials in a multilayer distributed Bragg reflector (DBR) are replaced by artificial materials with the so-called negative index of refraction. This provides an avenue for characterizing the…
Recently, modulation of the energy bandgap of graphene when gas molecules are adsorbed to its surface has been proved to be possible. Motivated by this, based on numerical calculations, we investigate the effect of the associated bandgap…
In this paper we present a theoretical analysis of the effect of local geometrical structure of the Fermi surface on the surface impedance of a metal at the anomalous skin effect. We show that when the Fermi surface includes nearly…
The logarithmic slope of the diffractive structure function is a potential observable scanning the hard and soft contributions in diffraction, allowing to disentangle the QCD dynamics. We report our calculations concerning this quantity, in…
The apparent brightness of satellites is calculated as a function of satellite position as seen by a ground-based observer in darkness. Both direct illumination of the satellite by the Sun as well as indirect illumination due to reflection…
Optical interference is not only a fundamental phenomenon that has enabled new theories of light to be derived but it has also been used in interferometry for the measurement of small displacements, refractive index changes and surface…
Studied experimentally the origin of the non-zero reflection of p-polarized radiation (TM) of Brewster's angle. The results have shown the residual reflected light in the vicinity of Brewster angle occurs due to inaccessibility 100%…
We consider the spectral response of moving diffraction gratings, in which the incident light extends over a broad angular range and where the diffracted light is observed from a specific angle. We show that the dispersion relation between…
Interfering liquid surface waves are generated by electrically driven vertical oscillations of two or more equispaced pins immersed in a liquid (water). The corresponding intensity distribution, resulting from diffraction of monochromatic…
Smith microfacet models are widely used in computer graphics to represent materials. Traditional microfacet models do not consider the multiple bounces on microgeometries, leading to visible energy missing, especially on rough surfaces.…
Geometric optics effectively describes the propagation of electromagnetic waves when the wavelength is much smaller than the characteristic length scale of the medium, making wave phenomena like diffraction negligible. As a result, light…
We present spherical analysis of electron backscatter diffraction (EBSD) patterns with two new algorithms: (1) band localisation and band profile analysis using the spherical Radon transform; (2) orientation determination using spherical…
The out-of-plane vibration of a rough surface causes an in-plane vibration of its speckle pattern when observed with a defocused optical photographic system. If the frequency of the oscillations is high enough, a time-averaged specklegram…
Geometrical optics provides an instructive insight into Brownian motion, ``pushed" into a large-deviations regime by imposed constraints. Here we extend geometrical optics of Brownian motion by accounting for diffusion inhomogeneity in…
Diffraction gratings are famous for their ability to exhibit, near a Wood anomaly, an arbitrarily large angular dispersion, e.g., with respect to the incidence angle or wavelength. For a diffraction grating under incidence by a plane wave…
Consider the incidence of a time-harmonic electromagnetic plane wave onto a biperiodic dielectric grating, where the surface is assumed to be a small and smooth perturbation of a plane. The diffraction is modeled as a transmission problem…
Accurately measuring the geometry and spatially-varying reflectance of real-world objects is a complex task due to their intricate shapes formed by concave features, hollow engravings and diverse surfaces, resulting in inter-reflection and…
Traditional physically-based material models rely on analytically derived bidirectional reflectance distribution functions (BRDFs), typically by considering statistics of micro-primitives such as facets, flakes, or spheres, sometimes…
Point imaging by a photonic crystal slab due to the negative refraction is studied theoretically. By investigating the transfer function of the imaging system, the influence of the surface termination to the imaging quality is analyzed. It…
Accurate material modeling is crucial for achieving photorealistic rendering, bridging the gap between computer-generated imagery and real-world photographs. While traditional approaches rely on tabulated BRDF data, recent work has shifted…