Related papers: Codebook Design for Channel Feedback in Lens-Based…
Reconfigurable intelligent surface (RIS) can improve the capacity of the wireless communication system by providing the extra link between the base station (BS) and the user. In order to resist the "multiplicative fading" effect, RIS is…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
This paper addresses the optimal design of limited-feedback downlink multi-user spatial multiplexing systems. A multiple-antenna base-station is assumed to serve multiple single-antenna users, who quantize and feed back their channel state…
We present a beamforming algorithm for multiuser wideband millimeter wave (mmWave) communication systems where one access point uses hybrid analog/digital beamforming while multiple user stations have phased-arrays with a single RF chain.…
A multiple antenna broadcast channel with perfect channel state information at the receivers is considered. If each receiver quantizes its channel knowledge to a finite number of bits which are fed back to the transmitter, the large…
Spatial multiplexing (SMX) multiple-input multiple-output (MIMO) over the best beamspace was considered as the best solution for millimeter wave (mmWave) communications regarding spectral efficiency (SE), referred as the best beamspace…
The large spectrum available in the millimeter-Wave (mmWave) band has emerged as a promising solution for meeting the huge capacity requirements of the 5th generation (5G) wireless networks. However, to fully harness the potential of mmWave…
Millimeter-wave (mmWave) communication in combination with massive multiuser multiple-input multiple-output (MU-MIMO) enables high-bandwidth data transmission to multiple users in the same time-frequency resource. The strong path loss of…
This paper considers an uplink multiuser massive multiple-input-multiple-output (MIMO) system with low-resolution analog-to-digital converters (ADCs), in which K users with a single-antenna communicate with one base station (BS) with Nr…
Reciprocity-based time-division duplex (TDD) Massive MIMO (multiple-input multiple-output) systems utilize channel estimates obtained in the uplink to perform precoding in the downlink. However, this method has been criticized of breaking…
Millimeter wave multiple-input multiple-output (mmWave-MIMO) systems with small number of radio-frequency (RF) chains have limited multiplexing gain. Spatial path index modulation (SPIM) is helpful in improving this gain by utilizing…
Supporting high mobility in millimeter wave (mmWave) systems enables a wide range of important applications such as vehicular communications and wireless virtual/augmented reality. Realizing this in practice, though, requires overcoming…
Millimeter-wave links are of a line-of-sight nature. Hence, multiple-input multiple-output (MIMO) systems operating in the millimeter-wave band may not achieve full spatial diversity or multiplexing. In this paper, we utilize reconfigurable…
This paper proposes a dimension reduction-based signal compression scheme for uplink distributed MIMO cloud radio access networks (C-RAN) with an overall excess of receive antennas, in which users are jointly served by distributed…
The performance of millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems is limited by the sparse nature of propagation channels and the restricted number of radio frequency (RF) chains at transceivers. The introduction of…
Achieving high channel estimation accuracy and reducing hardware cost as well as power dissipation constitute substantial challenges in the design of massive multiple-input multiple-output (MIMO) systems. To resolve these difficulties,…
Millimeter-wave (mmWave) communication plays a vital role to efficiently disseminate large volumes of data in beyond-5G networks. Unfortunately, the directionality of mmWave communication significantly complicates efficient data…
Exploiting channel sparsity at millimeter wave (mmWave) frequencies reduces the high training overhead associated with the channel estimation stage. Compressive sensing (CS) channel estimation techniques usually adopt the (overcomplete)…
The surge in mobile broadband data demands is expected to surpass the available spectrum capacity below 6 GHz. This expectation has prompted the exploration of millimeter wave (mm-wave) frequency bands as a candidate technology for next…
Millimeter-wave (mmWave) spectrum is expected to support data-intensive applications that require ultra-reliable low-latency communications (URLLC). However, mmWave links are highly sensitive to blockage, which may lead to disruptions in…