Related papers: $M$-QAM Precoder Design for MIMO Directional Modul…
In this paper, we consider the problem of preamble design in multiple-input multiple-output (MIMO) systems employing offset quadrature amplitude modulation based filter bank multicarrier (OQAM/FBMC) and propose a preamble optimization…
Multimode fibers (MMFs) offer a cost-effective connection solution for small and medium length networks. However, data rates through multimode fibers are traditionally limited by modal dispersion. Signal processing and Multiple-Input…
This paper investigates adaptive signal shaping methods for millimeter wave (mmWave) multiple-input multiple-output (MIMO) communications based on the maximizing the minimum Euclidean distance (MMED) criterion. In this work, we utilize the…
This paper proposes a simple and effective method for constructing higher-order three-dimensional (3D) signal constellations, aiming to enhance the reliability of digital communication systems. The approach systematically extends the…
Two-way relaying can improve spectral efficiency in two-user cooperative communications. It also has great potential in multiuser systems. A major problem of designing a multiuser two-way relay system (MU-TWRS) is transceiver or precoding…
The receiver design for multi-input multi-output (MIMO) ultra-reliable and low-latency communication (URLLC) systems can be a tough task due to the use of short channel codes and few pilot symbols. Consequently, error propagation can occur…
This paper studies the instantaneous rate maximization and the weighted sum delay minimization problems over a K-user multicast channel, where multiple antennas are available at the transmitter as well as at all the receivers. Motivated by…
Secure wireless information and power transfer based on directional modulation is conceived for amplify-and-forward (AF) relaying networks. Explicitly, we first formulate a secrecy rate maximization (SRM) problem, which can be decomposed…
For multi-user multiple-input and multiple-output (MIMO) wireless communications in orthogonal frequency di- vision multiplexing systems, we propose a MIMO precoding scheme providing a desired peak-to-average power ratio (PAR) at the…
The majority of modern communication systems adopts quadrature amplitude modulation (QAM) constellations as transmission schemes. Due to their square structure, however, QAM do not provide satisfying protection to phase noise effects as the…
The application of hybrid precoding in millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems has been proved effective for reducing the number of radio frequency (RF) chains. However, the maximum number of independent data…
Configuring hybrid precoders and combiners is a major challenge to deploy practical mmWave communication systems. Prior work addresses the problem of designing hybrid precoders and combiner, yet focusing on finding solutions under a total…
This paper investigates the hybrid precoding design for millimeter wave (mmWave) multiple-input multiple-output (MIMO) systems with finite-alphabet inputs. The mmWave MIMO system employs partially-connected hybrid precoding architecture…
Large-scale deployment of connected vehicles with cooperative awareness technologies increases the demand for vehicle-to-everything (V2X) communication spectrum in 5.9 GHz that is mainly allocated for the exchange of safety messages. To…
In this paper, we design constant modulus probing waveforms with good correlation properties for collocated multi-input multi-output (MIMO) radar systems. The main content is as follows: first, we formulate the design problem as a fourth…
Designing Doppler-resilient unimodular discrete phase-coded waveforms (DPWs) with low delay-Doppler sidelobes is critical for multiple-input multiple-output (MIMO) radar. Existing block coordinate descent (BCD) methods suffer from high…
The idea of media-based modulation (MBM) is to embed information in the channel states via intentional perturbations of the transmission media. This article covers a broad range of topics regarding MBM, expanding on its benefits and…
Aiming at maximizing the energy efficiency (EE) of multicast multibeam satellite communications, we consider the precoding design under the total power and quality of service (QoS) constraints. Since the original EE maximization problem is…
Using precoding to suppress multi-user interference is a well-known technique to improve spectra efficiency in multiuser multiple-input multiple-output (MU-MIMO) systems, and the pursuit of high performance and low complexity precoding…
We consider the problem of spatial signal design for multipath-assisted mmWave positioning under limited prior knowledge on the user's location and clock bias. We propose an optimal robust design and, based on the low-dimensional precoder…