Related papers: Fabrication and electrical transport properties of…
In this Letter, we present the patterning, exfoliation and micromanipulation of thin graphitic discs which are subsequently connected and patterned into sub-100nm wide ribbons with a resist-free process using Focused Ion Beam (FIB)…
The transport properties of highly oriented pyrolitic graphite (HOPG) and polycrystal graphite have been studied. The electric conductivity of HOPG is several times larger than that of the polycrystal graphite. Along with the large…
We report measurements of the electron transport through atomic-scale constrictions and tunnel junctions between ferromagnetic electrodes. Structures are fabricated using a combination of e-beam lithography and controlled electromigration.…
When diamond anvil cell (DAC) sample chambers are outfitted with both thermal insulation and electrodes, two cutting-edge experimental methods are enabled: Joule heating with spectroradiometric temperature measurement, and electrical…
We have made measurements of microwave transmission over the 12 - 18 GHz range and through a simple metamaterial exhibiting a negative index of refraction. The metamaterial consisted of an array of wires cladded in dielectric embedded in a…
Among all materials, mono-crystalline diamond has one of the highest measured thermal conductivities, with values above 2000 W/m/K at room temperature. This stems from momentum-conserving `normal' phonon-phonon scattering processes…
The performance of graphene-based transistors is often limited by the large electrical resistance across the metal-graphene contact. We report an approach to achieve ultra-low resistance metal contacts to graphene transistors. Through a…
Synthesis of multilayer graphene on copper wires by a chemical vapor deposition method is reported. After copper etching, the multilayer tube collapses forming stripes of graphitic films, their electrical conductance as a function of…
We study the low-temperature transport properties of 1D quantum wires as the confinement strength V_conf and the carrier density n_1D are varied using a combination of split gates and a top gate in GaAs/AlGaAs heterostructures. At…
The authors report on synthesis and thermal properties of the electrically-conductive thermal interface materials with the hybrid graphene-metal particle fillers. The thermal conductivity of resulting composites was increased by ~500% in a…
Graphene demonstrated potential for practical applications owing to its excellent electronic and thermal properties. Typical graphene field-effect transistors and interconnects built on conventional SiO2/Si substrates reveal the breakdown…
Graphene is a material with remarkable electronic properties and exceptional thermal transport properties near room temperature, which have been well examined and understood. However at very low temperatures the thermodynamic and thermal…
Electrical and thermal transport were studied in a vacuum-annealed polycrystalline silver wire with residual resistivity ratio 200-400, in the temperature range 0.1-1.2K and in magnetic fields up to 5T. Both at zero field and at 5T the wire…
An innovative way of producing large-scale unalloyed tantalum parts, based on the Wire + Arc Additive Manufacturing process, has been developed in this study. Two different unalloyed tantalum wires have been used to deposit 200-mm-long…
MgB2 hollow wires have been produced with a new technique which uses a conventional wire manufacturing process but is applied to composite billets containing the elemental B and Mg precursors in an appropriate shape. The technique has been…
In this letter we describe the observation of a magnetic field dependent electronic gap, suggestive of local superconductivity, in the point-contact spectrum of micro-crystalline graphite. Magnetic field dependent point-contact spectroscopy…
In this dissertation, thermal and electrical properties of aligned multiwall carbon nanotubes (MWNTs) prepared by thermal decomposition of hydrocarbons have been experimentally studied. The thesis consists of six chapters. Ch1 is an…
Controllable geometric manipulation via micromachining techniques provides a promising tool for enhancing useful topological electrical responses relevant to future applications such as quantum information science. Here we present…
Conductive ferroelectric domain walls (DWs) represent a promising topical system for the development of nanoelectronic components and device sensors to be operational at elevated temperatures. DWs show very different properties as compared…
Micrometer-scale thin diamond devices are key components for various quantum sensing and networking experiments, including the integration of color centers into optical microcavities. In this work, we introduce a laser-cutting method for…