Related papers: 1.5 $\mu$m lasers with sub 10 mHz linewidth

We describe the design and operation of a high-stability Fabry-Perot cavity, for laser stabilization in cavity quantum-electrodynamics experiments. Our design is based on an inexpensive and readily available uniaxial carbon-fiber reinforced…

We report on the development and performance evaluation of an ultra-stable clock laser for an $\rm ^{27}Al^+$ optical clock. The thermal noise limited ultra-stable laser is developed based on a 30 cm long ultra-stable cavity. Three…

We present an in-vacuum bonded, 9.7 mL-volume Fabry-P\'erot ultrastable optical reference cavity that operates without a vacuum enclosure. A laser stabilized to the cavity demonstrates low, thermal noise-limited phase noise and 5x10^{-14}…

Mutual phase coherence is the most crucial factor in asynchronous optical sampling system, and its enhancement is commonly achieved by phase-locking both femtosecond lasers to a shared narrow-linewidth cavity-stabilized laser. Here we…

We demonstrate two fully and tightly phase locked 750 MHz ytterbium (Yb) fiber frequency combs that are independently stabilized to a continuous wave (CW) laser with <1 rad RMS phase error. A bulk EOM and a single stack PZT are separately…

We have explored the performance of two "dark fibers" of a commercial telecommunication fiber link for a remote comparison of optical clocks. The two fibers, linking the Leibniz University of Hanover (LUH) with the Physi-kalisch-Technische…

A stable optical resonator has been built using a 30 micrometer-wide, metal-coated microcantilever as one mirror. The second mirror was a 12.7 mm-diameter concave dielectric mirror. By positioning the two mirrors 75 mm apart in a…

Residual motion of the arm cavity mirrors is expected to prove one of the principal impediments to systematic lock acquisition in advanced gravitational-wave interferometers. We present a technique which overcomes this problem by employing…

We report on the characterization, including residual phase noise and fractional frequency instability, of fiber-coupled PPLN non-linear crystals. These components are devoted to frequency doubling 871 nm light from an extended-cavity diode…

We have quantified a short term instability budget for an optical frequency standard based on cold, freely expanding calcium atoms. Such systems are the subject of renewed interest due to their high frequency stability and relative…

Phase coherent fibers (PCF) are essential to distribute nearly monochromatic photons, ultra-stable in their frequency and phases, which have demanding requirements for state-of-the-art networked experiments, quantum as well as very…

We demonstrate a straight-forward technique to measure the linewidth of a grating-stabilized diode laser system---known as an external cavity diode laser (ECDL)---by beating the output of two independent ECDLs in a Michelson interferometer,…

An extended cavity diode laser operating in the Littrow configuration emitting near 657 nm is stabilized via its injection current to a reference cavity with a finesse of more than 10^5 and a corresponding resonance linewidth of 14 kHz. The…

Metrology experiments can be limited by the noise produced by the laser involved via small fluctuations in the laser's power or frequency. Typically, active power stabilization schemes consisting of an in-loop sensor and a feedback control…

We synchronize a 8.06-GHz microwave signal from a voltage-controlled oscillator with an optical pulse train from a 77.5- MHz mode-locked Er-fiber laser using a fiber-based optical-microwave phase detector. The residual phase noise between…

We demonstrate an on-chip lithium niobate micro-disk laser based on hydrogen cyanide (H13C14N) gas saturation absorption method for frequency stabilization. The laser chip consists of two main components: a micro-disk laser and a combined…

Ultra-low-noise stabilized lasers are a fundamental tool for precision quantum technologies, optical clocks, microwave and millimeter-wave generation, and fiber sensing. Existing systems rely on table-top bulk-optic components -- discrete…

A major limitation of laser interferometers using continuous wave lasers are parasitic light fields, such as ghost beams, scattered or stray light, which can cause non-linear noise. This is especially relevant for laser interferometric…

Many precision laser applications require active frequency stabilization. However, such stabilization loops operate by pushing noise to frequencies outside their bandwidth, leading to large "servo bumps" that can have deleterious effects…

Ultralow noise, yet tunable lasers are a revolutionary tool in precision spectroscopy, displacement measurements at the standard quantum limit, and the development of advanced optical atomic clocks. Further applications include LIDAR,…