Related papers: Sense Amplifier Comparator with Offset Correction …
The purpose of this project was to design and implement a pipeline Analog-to-Digital Converter using 0.35um CMOS technology. Initial requirements of a 25-MHz conversion rate and 8-bits of resolution where the only given ones. Although…
Resistive switching devices, important for emerging memory and neuromorphic applications, face significant challenges related to control of delicate filamentary states in the oxide material. As a device switches, its rapid conductivity…
This paper describes a pipelined analog-to-digital converter (ADC) employing a power and area efficient architecture. The adjacent stages of a pipeline share operational amplifiers. In order to keep accuracy of the amplifiers in the first…
This paper proposes an advanced control strategy to eliminate both current sharing error and DC circulating current caused by line impedance mismatched and measurement errors in islanded AC microgrid system. The proposed adaptive virtual…
This article is present high precision multiwave rectifier circuit operating in low voltage plus or minus 1.5 Volt current modes by CMOS technology 0.5 \mum, receive input and give output in current mode, respond at high frequency period.…
Multi-antenna precoding effectively mitigates the interference in wireless networks. However, the resultant performance gains can be significantly compromised in practice if the precoder design fails to account for the inaccuracy in the…
This paper presents a novel adaptive reduced-rank multi-input-multi-output (MIMO) decision feedback equalization structure based on joint iterative optimization of adaptive estimators. The novel reduced-rank equalization structure consists…
The true-differential superconductor on-chip amplifier has complementary outputs that float with respect to chip ground. This improves signal integrity and compatibility with the receiving semiconductor stage. Both source-terminated and…
A four-stage operational transconductance amplifier (OTA) for ultra-low-power applications is introduced in this paper. The proposed circuit inclusive of frequency compensation requires minimal transistor count and passives, overcoming the…
This paper presents the design and analysis of a compensation method with application to a 345 kV 480 MVA three-phase transmission line. The compensator system includes a series injected voltage source converter that minimizes the resonance…
A novel background calibration technique for Time-Interleaved Analog-to-Digital Converters (TI-ADCs) is presented in this paper. This technique is applicable to equalized digital communication receivers. As shown by Tsai et al. [1] and Luna…
Memristive neuromorphic systems are designed to emulate human perception and cognition, where the memristor states represent essential historical information to perform both low-level and high-level tasks. However, current systems face…
Sensor calibration is an indispensable task in any networked cyberphysical system. In this paper, we consider a sensor network plagued with offset errors, measuring a rank-1 signal subspace, where each sensor collects measurements under a…
In this paper, various Miller-compensated amplifiers are analyzed by using the two-port feedback analysis together with the root-locus diagram. The proposed analysis solves problems of Miller theorem/approximation that fail to predict a…
This paper describes a CMOS analogy voltage supper buffer designed to have extremely low static current Consumption as well as high current drive capability. A new technique is used to reduce the leakage power of class-AB CMOS buffer…
Quantum sensing is an important application of emerging quantum technologies. We explore whether a hybrid system of quantum sensors and quantum circuits can surpass the classical limit of sensing. In particular, we use optimization…
The present article primarily focuses on the design of an ultra-low-noise amplifier specifically tailored for quantum applications. The circuit design places a significant emphasis on improving the noise figure, as quantum-associated…
Control Loop Feedback Mechanism for Generic Array Logic Chip Multiprocessor is presented. The approach is based on control-loop feedback mechanism to maximize the efficiency on exploiting available resources such as CPU time, operating…
An instrumentation amplifier (InAmp) is an electronic device used in many applications, where test and measuring accuracy is required. However, one of the drawbacks of an InAmp is limited operation gain range. In this paper, we investigate…
This study unveils a comprehensive design strategy, intricately addressing the realization of transmon qubits, the design of Josephson parametric amplifiers, and the development of an innovative fully integrated receiver dedicated to…