Related papers: Actively Calibrated Line Mountable Capacitive Volt…
The Laboratory of Metrology in Electrical Standards of Inmetro (Lampe) has built, in 2010, a transformer which is able to perform inductive voltage divider ratio calibrations using the bootstrap method. This transformer was idealized…
This paper proposes a new design for realizing grounded and floating meminductor emulators built with two operational transconductance amplifiers (OTAs) and two second-generation current conveyors. The proposed grounded and floating…
This paper proposes a cascaded multiwire-power line communication (PLC)/multiple-visible light communication (VLC) system. This hybrid architecture offers low installation cost, enhanced performance, practical feasibility, and a wide range…
Phasor Measurement Unit measurement data have been widely used in nowadays power system applications both in steady state and dynamic analysis. The performance of these applications running in utilities' energy management system depends…
Uncalibrated instrument transformers (ITs) can degrade the performance of downstream applications that rely on the voltage and current measurements that ITs provide. It is also well-known that phasor measurement unit (PMU)-based system-wide…
In this paper, an actuator active fault-tolerant controller (FTC) is proposed for the voltage source converter (VSC) which interfaces a distributed energy resource (DER) to the power grid. The proposed active FTC includes two units:…
The process of calibrating instrument transformers (ITs) has been greatly simplified by using phasor measurement unit (PMU) data since this process eliminates the need for (a) additional hardware, and (b) taking ITs offline. However, such…
In this paper, a new Volt/Var Control (VVC) scheme is proposed to facilitate the coordination between the conventional VVC devices and the new smart PV inverters to provide an effective voltage control on a system with high PV penetration.…
A detailed characterisation of a combined Linear Variable Differential Transformer (LVDT) position sensor and voice-coil (VC) actuator designed for seismic isolation systems in gravitational wave detectors is presented. A dedicated…
A modular and scalable converter for medium voltage (MV) AC to low voltage (LV) DC power conversion is proposed; single-phase-modules (SPMs), each consisting of an active-front-end (AFE) stage and an isolated DC-DC stage, are connected in…
Machine learning-based classifiers are commonly evaluated by metrics like accuracy, but deeper analysis is required to understand their strengths and weaknesses. MLMC is a visual exploration tool that tackles the challenge of multi-label…
Capacitive devices are customarily used as probes to measure the level of noble liquids in detectors operated for neutrino studies and dark matter searches. In this work we describe the use of a high-temperature superconducting material as…
The most common method to measure direct current high voltage (HV) down to the ppm-level is to use resistive high-voltage dividers. Such devices scale the HV into a range where it can be compared with precision digital voltmeters to…
A robust Learning Model Predictive Controller (LMPC) for uncertain systems performing iterative tasks is presented. At each iteration of the control task the closed-loop state, input and cost are stored and used in the controller design.…
This paper develops a predictive modeling algorithm, denoted as Real-Time Vector Fitting (RTVF), which is capable of approximating the real-time linearized dynamics of multi-input multi-output (MIMO) dynamical systems via rational transfer…
Mid-circuit measurements (MCMs) are critical components of the quantum error correction protocols expected to enable utility-scale quantum computing. MCMs can be modeled by quantum instruments (a type of quantum operation or process), which…
Recent research on multilevel inverters shows exciting properties, including the potential to generate multiple output voltages and integrated voltage boosting. However, most presented inverter topologies have a restricted number of output…
Voltage support capability is critical for grid-forming (GFM) inverters with current-limiting control (CLC) during grid faults. Despite the findings on the voltage support for symmetrical grid faults, its applicability to more common but…
Distributed Volt-Var Control (VVC) is a widely used control mode of smart inverters. However, necessary VVC curve parameters are remotely communicated to the smart inverter, which opens doors for cyberattacks. If the VVC curves of an…
Multilevel Monte Carlo (MLMC) is a flexible and effective variance reduction technique for accelerating reliability assessments of complex power system. Recently, data-driven surrogate models have been proposed as lower-level models in the…