Related papers: Cascaded Incremental Nonlinear Dynamic Inversion C…
This paper presents the inverse kinematic analysis and parameters identification of a novel aerial manipulation system. This system consists of 2-link manipulator attached to the bottom of a quadrotor. This new system presents a solution…
The proportional-integral-derivative (PID) controller and its variants are widely used in control engineering, but they often rely on linearization around equilibrium points and empirical parameter tuning, making them ineffective for…
In this thesis, advanced design technique in sliding mode control (SMC) is presented with focus on PID (Proportional-Integral-Derivative) type Sliding surfaces based Sliding mode control with improved power rate exponential reaching law for…
Many robotic systems are underactuated, meaning not all degrees of freedom can be directly controlled due to lack of actuators, input constraints, or state-dependent actuation. This property, compounded by modeling uncertainties and…
Bio-inspired methods can provide efficient solutions to perform autonomous landing for Micro Air Vehicles (MAVs). Flying insects such as honeybees perform vertical landings by keeping flow divergence constant. This leads to an exponential…
In recent years, unmanned aerial vehicles (UAVs) are used for numerous inspection and video capture tasks. Manually controlling UAVs in the vicinity of obstacles is challenging, however, and poses a high risk of collisions. Even for…
Proportional-integral-derivative (PID) control, the most common control strategy in the industry, always suffers from health problems resulting from external disturbances, improper tuning, etc. Therefore, there have been many studies on…
This paper presents a solution for the state estimation and control problems for a class of unconventional vertical takeoff and landing (VTOL) UAVs operating in forward-flight conditions. A tightly-coupled state estimation approach is used…
This paper presents a geometric adaptive control scheme for a quadrotor unmanned aerial vehicle, where the effects of unknown, unstructured disturbances are mitigated by a multilayer neural network that is adjusted online. The stability of…
Featuring the fast response and flexibility in control allocation, an electric vehicle with in-wheel motors is a good platform for implementing advanced vehicle dynamics control. Among many active safety functions of an in-wheel motor…
As a physical layer security technology, directional modulation (DM) can be combined with intelligent reflect-ing surface (IRS) to improve the security of drone communications. In this paper, a directional modulation scheme assisted by the…
Visual-inertial SLAM systems often exhibit suboptimal performance due to multiple confounding factors including imperfect sensor calibration, noisy measurements, rapid motion dynamics, low illumination, and the inherent limitations of…
Unmanned Aerial Vehicles (UAVs) rely on measurements from Inertial Measurement Units (IMUs) to maintain stable flight. However, IMUs are susceptible to physical attacks, including acoustic resonant and electromagnetic interference attacks,…
Aerial manipulation (AM) expands UAV capabilities beyond passive observation to contact-based operations at high altitudes and in otherwise inaccessible environments. Although recent advances show promise, most AM systems are developed in…
Incremental input-to-state stability (delta-ISS) offers a robust framework to ensure that small input variations result in proportionally minor deviations in the state of a nonlinear system. This property is essential in practical…
This paper addresses the problem of thrust estimation and control for the rotors of small-sized multirotors Uncrewed Aerial Vehicles (UAVs). Accurate control of the thrust generated by each rotor during flight is one of the main challenges…
The capability to autonomously track a non-cooperative target is a key technological requirement for micro aerial vehicles. In this paper, we propose an output feedback control scheme based on deep reinforcement learning for controlling a…
Conventional Feedback-Linearization-based controller, applied to the tilt-rotor (eight inputs), results in the extensive changes in the tilting angles, which are not expected in practice. To solve this problem, we introduce the novel…
Proportional-Integral-Derivative (PID) control is used for automatically regulating a measurable quantity to a desired setpoint. It is widely used in different types of classical control electronics. Here, we show how extending the feedback…
Micro Aerial Vehicles (MAVs) navigation in subterranean environments is gaining attention in the field of aerial robotics, however there are still multiple challenges for collision free navigation in such harsh environments. This article…