Related papers: Insulating titanium oxynitride for visible light p…
We present the intrinsic optical properties over a broad spectral range of TiN thin films deposited on a Si/SiO$_2$ substrate. We analyze the measured reflectivity spectra of the film-substrate multilayer structure within a well-establish…
We report on the electrical properties of polycrystalline NbO2 thin film vertical devices grown on TiN coated SiO2/Si substrates using pulsed laser deposition. First, we analyzed the thickness and contact size dependences of threshold…
Low-dose nitrogen implantation induces in TiO2 nanotubes a co-catalytic activity for photocatalytic H2-evolution. The use of an ion implantation process leads to a N-implanted zone only at the top part of the tubes. The coupling of this top…
Photoelectrochemical solar water splitting is a promising approach to convert solar energy into sustainable hydrogen fuel using semiconductor electrodes. Due to their visible light absorption properties, oxynitrides have shown to be…
TiO2 with super narrow bandgap (1.1 eV~) are successfully synthesized via a facile and novel one-step single-mode magnetic microwave induced plasma treatment. The selectively surface Ti3+-doping on obtained TiO2 as trapping centers which…
Light chargeable metal-ion batteries using semiconductor heterostructures are gaining enormous interest. A few such heterostructures such as MoS2/MoOy and TiS2/TiO2 have been shown to function as photocathodes in photochargeable Li-ion…
TiO$_2$ and WO$_3$ are two of the most important earth-abundant electronic materials with applications in countless industries. Recently alloys of WO$_3$ and TiO$_2$ have been investigated leading to improvements of key performance…
Absorption of light in superconducting electronics is a major limitation on the quality of circuit architectures that integrate optical components with superconducting components. A 10 nm thick film of a typical superconducting material…
In this work we study the optoelectronic properties of individual TiO2 fibres produced through coupled sol-gel and electrospinning, by depositing them onto pre-patterned Ti/Au electrodes on SiO2/Si substrates. Transport measurements in the…
The size of the band gap and the energy position of the band edges make several oxynitride semiconductors promising candidates for efficient hydrogen and oxygen production under solar light illumination. The intense research efforts…
We present the results of XPS measurements (core levels and valence bands) of solution processed TiOx thin films prepared from titanium butoxide (C16H36O4Ti) diluted in isopropanol which is a common sol-gel route for fabricating TiOx…
Titanium dioxide (TiO2) nanocrystals were prepared by wet chemical method and characterized by x-ray diffraction (XRD), transmission electron microscopy (TEM), Raman scattering (RS) and photoluminescence (PL). The X-ray diffraction shows…
Present study investigates the photoabsorption properties of single crystal rutile TiO2 (110) surfaces after they have been implanted with low fluence of Cobalt ions. The surfaces, after implantation, demonstrate fabrication of…
We fabricated NiFe$_\textrm{2}$O$_\textrm{x}$ thin films on MgAl$_2$O$_4$(001) substrates by reactive dc magnetron co-sputtering varying the oxygen partial pressure during deposition. The fabrication of a variable material with oxygen…
We report magnetic, optical and oxidation states of oxygen deficient TiO$_{2-\delta}$ nanoparticles (NPs) synthesized by environment-friendly green route using Phyllanthus niruri (PN) whole plant extract instead of leaf extract. Rietveld…
Titanium dioxide is one of the most widely used wide bandgap materials. However, the TiO2 deposited on a substrate is not always transparent leading to a loss in efficiency of the device, especially, the photo response. Herein, we show that…
In the search for new renewable energy to replace fossil fuels, Hydrogen is one of the most promising candidates for clean energy production. But cheap Hydrogen separation and storage is still a big challenge. Photoelectrochemical devices…
The oxide-metal-oxide architecture is a promising approach for the development of the high-performance indium-free transparent electrode (TE), which is a key component of various optoelectronic applications such as solar cells, organic…
Being one of the strongest materials, ternary TiSiN exhibits a very interesting family of binary transition metal nitride and silicide systems. A novel technique to fabricate morphologically fascinating nano and micro structures of TiSiN is…
Band engineering is employed thoroughly and targets technologically scalable photoanodes for solar water splitting applications. Complex and costly recipes are necessary, often for average performances. Here we report simple photoanode…