Related papers: SOI RF Switch for Wireless Sensor Network

We compare modulator designs on thick-film and thin-film silicon-on-insulator (SOI) substrates based on the carrier-depletion effect. This effect exhibits a lower junction capacitance as compared to its injection counterparts, leading to a…

A photonic wireless bridge operating at a carrier frequency of 250 GHz is proposed and demonstrated. To mitigate the phase noise of the free-running lasers present in such a link, the tone-assisted carrier recovery is used. Compared to the…

Fiber-optic transmission of high radiofrequency (RF) signals is being established as a key means for efficiently dealing with the ever-demanding bandwidth, services and cost requirements of modern broadband wireless networks and systems.…

A polarization-independent reconfigurable frequency selective rasorber (FSR)/absorber with low insertion loss based on diodes is proposed in this paper. The presented structure consists of a lossy layer based on square loops and a bandpass…

We consider a network of single-antenna sensors that observe an unknown deterministic parameter. Each sensor applies a phase shift to the observation and the sensors simultaneously transmit the result to a multi-antenna fusion center (FC).…

A miniaturized linearly-polarized patch antenna is presented for Wireless Power Transfer (WPT) at 1. 8 GHz. The proposed antenna consists of a patch element and a 3-turn Complementary Spiral Resonator (3-CSR) with antenna dimension of 50 mm…

This paper presents a 17 bit analogue-to-digital converter that incorporates mismatch and quantisation noise-shaping techniques into an energy-saving 10 bit successive approximation quantiser to increase the dynamic range by another 42 dB.…

We present a novel photonic wire-to-slot waveguide coupler in SOI. The phase matching between a wire and slot mode is achieved using a mode transformer. The architecture consists of a balanced 50/50 power splitter and a tunable phase…

Rapid single shot spin readout is a key ingredient for fault tolerant quantum computing with spin qubits. An RF-SET (radio-frequency single electron transistor) is predominantly used as its the readout timescale is far shorter than the spin…

Enhancing the energy efficiency of devices stands as one of the key requirements in the fifth-generation (5G) cellular network and its evolutions toward the next generation wireless technology. Specifically, for battery-limited…

This letter investigates the artificial noise aided beamforming design for secure simultaneous wireless information and power transfer (SWIPT) in a two-tier downlink heterogeneous network, where one femtocell is overlaid with one macrocell…

This paper investigates the simultaneous wireless information and power transfer (SWIPT) precoding scheme for K-user multiple-input-multiple-output (MIMO) interference channels (IC), for which interference alignment (IA) schemes provide…

X-ray SOI pixel sensors, "XRPIX", are being developed for the next-generation X-ray astronomical satellite, "FORCE". The XRPIX are fabricated with the SOI technology, which makes it possible to integrate a high-resistivity Si sensor and a…

A hemispherical multilayer wide-band (7-13 GHz) band-pass frequency selective surface (FSS) is reported. A new design technique based on a Goldberg discretization and unit cell scaling technique is introduced to accommodate the curved…

The demand for a fast high-frequency read-out of high impedance devices, such as quantum dots, necessitates impedance matching. Here we use a resonant impedance matching circuit (a stub tuner) realized by on-chip superconducting…

This paper presents the design and the realization of a hybrid wireless Gigabit Ethernet indoor communications system operating at 60 GHz. As the 60 GHz radio link operates only in a single-room configuration, an additional Radio over Fiber…

For the characterization of components, systems and signals in the RF and microwave range, several dedicated instruments are in use. In this paper the fundamentals of the RF-signal sampling technique, which has found widespread applications…

A single-switch-regulated wireless power transfer (WPT) receiver is presented in this letter. Aiming at low-cost applications, the system involves only a single-switch class-E resonant rectifier, a frequency synchronization circuit, and a…

EDGE-based EC-GSM-IoT is a promising candidate for the billion-device cellular IoT (cIoT), providing similar coverage and battery life as NB-IoT. The goal of 20 dB coverage extension compared to EDGE poses significant challenges for the…

Hybrid acoustic-RF systems offer excellent ranging accuracy, yet they typically come at a power consumption that is too high to meet the energy constraints of mobile IoT nodes. We combine pulse compression and synchronized wake-ups to…