Related papers: Contact resistance between two REBCO tapes under l…
We have measured magnetoresistance of suspended graphene in the Corbino geometry at magnetic fields up to $B=0.15\,$T, i.e., in a regime uninfluenced by Shubnikov-de Haas oscillations. The low-temperature relative magnetotoresistance…
Protecting a high temperature superconducting (HTS) magnet from a quench event is a challenging task. Because of the slow normal zone propagation velocity, the long reliable quench detection method by directly monitoring coil voltage may…
The investigation of transport characteristics in high-temperature superconductors under magnetic fields is one of the most important topics in condensed matter physics and transport applications. For YBa$_2$Cu$_3$O$_7$ (YBCO), the…
While in a triggered experiment the matching of the RPC transmission line impedance with the one of the front-end electronics is less critical, for a trigger-less data recording this becomes mandatory. As expected, impedance matching is not…
We compare the temperature dependence of resistivity \rho(T) of Si MOSFETs with the recent theory by Zala et al. This comparison does not involve any fitting parameters: the effective mass m* and g*-factor for mobile electrons have been…
Magnetoresistive properties of granular Bi-based HTSC with trapped magnetic fields are investigated in the temperature region near superconducting transition . The effect of trapped field and transport current values and orientations on the…
The electrophysical reaction of rubidium polytungstate Rb4W11O35 ceramics (RPTC) on fast humidity impact has been investigated by studying the influence of wet air pulse of 1-3 s of duration on the peculiarities of dynamic current-voltage…
The field error due to magnetization of superconductors in a superconducting magnet can significantly compromise the field homogeneity which is extremely important for NMR magnets. This is especially true for high Tc superconducting…
The accurate extraction and the reliable, repeatable reduction of graphene - metal contact resistance (R$_{C}$) are still open issues in graphene technology. Here, we demonstrate the importance of following clear protocols when extracting…
The magnetoresistance (MR) effect in metallic atomic-sized contacts is studied theoretically by means of first-principle electronic structure calculations. We consider three-atom chains formed from Co, Cu, Si, and Al atoms suspended between…
Recent experiments in approximately 10nm size electrodeposited Ni-Ni nanocontacts have shown ballistic magnetoresitance values of 700% stable during a week (Garcia et al Appl. Phys. Lett. 79, 4550(2001) and very recently up to 3000% (Chopra…
Vertical packaging of multiple Giant Magnetoresistance (multi-GMR) stacks is a very interesting noise reduction strategy for local magnetic sensor measurements, which has not been reported experimentally so far. Here, we have fabricated…
Many superconducting power applications contain REBCO coils. Superconducting motors are very interesting for mobile applications like aviation, thanks to their high power per unit weight. In order to reduce the inductance, multi-tape…
Despite extensive experimental and theoretical efforts, the important issue of the effects of surface magnetic impurities on the topological surface state of a topological insulator (TI) remains unresolved. We elucidate the effects of Cr…
Slow magnetic relaxation and two level fluctuations measurements under high current injection is performed in single-contacted ferromagnetic nanostructures. The magnetic configurations of the samples are described by two metastable states…
We develop an analytic framework to extract circuit parameters and loss tangent from superconducting transmission-line resonators terminated by reactive loads, extending analysis beyond the perturbative regime. The formulation yields…
A high-field winding can be fabricated from a cable of non-insulated REBCO tapes, stacked face-face without twisting. If the cable is oriented within each turn of a winding so that the tape face is closely parallel to the magnetic field at…
We report here that magnetic fields of almost 34 T, far above the upper 24 T limit of Nb3Sn, can be generated using a multifilament round wire conductor made of the high temperature cuprate superconductor Bi2Sr2CaCu2O8-x (Bi-2212). A…
The Hall resistivity rho_{xy} of LuNi_2B_2C is negative in the normal as well as in the mixed state and has no sign reversal typical for high-T_c superconductors. A distinct nonlinearity in the rho_{xy} dependence on field H was found in…
We propose a multi-terminal(Non-magnetic) mesoscopic electrical transport measurement for measuring Rashba spin orbit strength. The method proposed is different from the usual magneto transport measurements, which require magnetic fields…