Related papers: Supersonic Impact of Metallic Micro-particles
This work is a theoretical study of the speed at which the material of an impacted target is ejected during the formation of an impact crater. Our model, starting from the first principle of thermodynamics, can describes the speed of the…
Collisions between amorphous Fe nanoparticles were studied using molecular-dynamics simulation. For head-on collisions of nanoparticles with radii $R =$ 1.4 nm, $R =$ 5.2 nm, and $R =$ 11 nm, sticking was observed at all simulated…
Particles of low velocity, travelling without dissipation in a superfluid, can interact and emit sound when they collide. We propose a minimal model in which the equations of motion of the particles, including a short-range repulsive force,…
Drop impact causes severe surface erosion, dictating many important natural, environmental and engineering processes and calling for substantial prevention and preservation efforts. Nevertheless, despite extensive studies on the kinematic…
The shear-modulus and yield-stress of amorphous solids are important material parameters, with the former determining the rate of increase of stress under external strain and the latter being the stress value at which the material flows in…
High velocity impact between crystalline surfaces is important for a range of material phenomena, yet a fundamental understanding of the effect of surface structure, energetics and kinetics on the underlying thermo-mechanical response…
We theoretically investigate the interaction between a single molecule and a metallic nanoparticle. We develop a general quantum mechanical description for the calculation of the enhancement of radiative and non-radiative decay channels for…
Employing acoustofluidic simulations, we study the propulsion of cone-shaped nano- and microparticles by a traveling ultrasound wave. In particular, we investigate how the acoustic propulsion of the particles depends on their size and the…
We study the influence of the surface energy and contamination films on rubber adhesion and sliding friction. We find that there is a transfer of molecules from the rubber to the substrate which reduces the work of adhesion and makes the…
We present three-dimensional measurements of size-dependent acoustophoretic motion of microparticles with diameters from 4.8 um down to 0.5 um suspended in either homogeneous or inhomogeneous fluids inside a glass-silicon microchannel and…
Arbitrary waves incident on a solid embedded nanoparticle are studied. The acoustic vibrational frequencies are shown to correspond to the poles of the scattering cross section in the complex frequency plane. The location of the poles is…
Understanding the mechanical properties of metals at extreme conditions is essential for the advancement of miniaturized technologies. As dimensions decrease, materials will experience higher strain rates at the same applied velocities.…
Shock-physics numerical codes are essential tools for describing the short but extreme fragmentation stage of the hypervelocity impact process on asteroids. However, accurately representing complex interior structures, surfaces, and contact…
The influence of the electromagnetic irradiation pressure on a spheroidal metallic nanoparticle at the frequencies close to the surface plasmon vibrations has been considered. With the action of the radiation pressure, the polarizability of…
Enhanced optical absorption of molecules in the vicinity of metallic nanostructures is key to a number of surface-enhanced spectroscopies and of great general interest to the fields of plasmonics and nano-optics. Yet, experimental access to…
Structural superlubricity is an intriguing physical phenomenon, whereby sliding at a structurally incommensurate, atomically flat interface yields vanishingly small friction forces. Despite its recent experimental validation, critical…
A system of inelastic hard disks in a thin pipe capped by hot walls is studied with the aim of investigating velocity correlations between particles. Two effects lead to such correlations: inelastic collisions help to build localized…
Mass-angle correlation of fission fragments has been understood as manifestation of quasifission. We show that this is not so: the effect can originate from correlation between fusion-fission amplitudes with different total spins signifying…
The jamming transition is an important feature of granular materials, with prior work showing an excess of low frequency modes in the granular analog to the density of states, the granular density of modes. In this work, we present an…
Current engineering wear models are often based on empirical parameters rather than built upon physical considerations. Here, we look for a physical description of adhesive wear at the microscale, at which the interaction between two…