Related papers: A Gating Grid Driver for Time Projection Chambers
Energy dispersion and spin orientation of the protected states at interfaces between topological insulators (TIs) and non-topological materials depend on the charge redistribution, strain, and atomic displacement at the interface. Knowledge…
During grid faults, grid-forming converters are typically suggested to switch from a voltage-source to a current-source mode to limit the current and protect the electronics. This transition has the potential for the converter to…
Invertible logic can operate in one of two modes: 1) a forward mode, in which inputs are presented and a single, correct output is produced, and 2) a reverse mode, in which the output is fixed and the inputs take on values consistent with…
Event-triggered approach to networked control systems is used to reduce the workload of the communication network. For the static output-feedback continuous event-trigger may generate an infinite number of sampling instants in finite time…
A fast and accurate grid impedance measurement of three-phase power systems is crucial for online assessment of power system stability and adaptive control of grid-connected converters. Existing grid impedance measurement approaches…
The paradigm of graphene transistors is based on the gate modulation of the channel carrier density by means of a local channel gate. This standard architecture is subject to the scaling limit of the channel length and further restrictions…
In this work, we introduce two schemes to construct reusable garbled circuits (RGCs) in the semi-honest setting. Our completely reusable garbled circuit (CRGC) scheme allows the generator (party A) to construct and send an obfuscated…
A new particle detector with sub-nanosecond time resolution capable of working in high-rate environment (rate capability of the order of $MHz/ cm^2$) is under developmnet. Semiconductive electrodes with resistivity $\rho$ up to $10^8…
The paper deals with the modelling and control of a double winded induction generator. The controlled process is an induction generator with distinct excitation winding. At the generator terminal is connected a load (electrical consumer).…
The requirement of high rate capability for operation at LHC, led 20 years ago to the achievement of Resistive Plate Chambers operated in avalanche mode, thanks to the introduction of new gas mixtures and to the development of the Front-End…
In conventional metal-oxide semiconductor (CMOS) electronics, the logic state of a device is set by a gate voltage (VG). The superconducting equivalent of such effect had remained unknown until it was recently shown that a VG can tune the…
The upgrade of the Resistive Plate Chamber (RPC) detector, in order to increase the detector rate capability and to be able to work efficiently in high rate environment, consists in the reduction of the operating voltage along with the…
The absence of a band-gap in graphene limits the gate modulation of its electron conductivity, both in regular graphene as well as in PN junctions, where electrostatic barriers prove transparent to Klein tunneling. We demonstrate a novel…
The application of a gate voltage to control the superconducting current flowing through a nanoscale superconducting constriction, named as gate-controlled supercurrent (GCS), has raised great interest for fundamental and technological…
To date, endeavors in nanoscale spintronics are dominated by the use of single-electron or single-spin transistors having at their heart a semiconductor, metallic or molecular quantum dot who's localized states are non-spin-degenerate and…
Electrical spin injection from ferromagnetic metals into graphene is hindered by the impedance mismatch between the two materials. This problem can be reduced by the introduction of a thin tunnel barrier at the interface. We present room…
This paper presents the results of a model predictive controller (MPC) development for diesel engine air-path regulation. The control objective is to track the intake manifold pressure and exhaust gas recirculation (EGR) rate targets by…
We consider the problem of guaranteeing that the transient voltages and currents stay within prescribed bounds in Direct Current (DC) microgrids, when the controller does not have access to accurate system dynamics due to the load being…
The MICROMEGAS (MICRO-MEsh GAseous Structure) charge amplification structure has found wide use in many detection applications, especially as a gain stage for the charge readout of Time Projection Chambers (TPCs). Here we report on the…
Network segmentation of a power grid's communication system is one way to make the grid more resilient to cyber attacks. We develop a novel trilevel programming model to optimally segment a grid communication system, taking into account the…