Related papers: Improper Signaling in Two-Path Relay Channels
In the transmission of digital data at a relatively high rate over a particular band limited channel, it is normally necessary to employ an equalizer at the receiver in order to correct the signal distortion introduced by the channel .ISI…
The analysis and optimization of single intelligent reflecting surface (IRS)-assisted systems have been extensively studied, whereas little is known regarding multiple-IRS-assisted systems. This paper investigates the analysis and…
Reconfigurable Intelligent Surfaces (RISs) are expected to be massively deployed in future beyond-5th generation wireless networks, thanks to their ability to programmatically alter the propagation environment, inherent low-cost and…
In this paper, the transmission of an improper-complex second-order stationary data sequence is considered over a strictly band-limited frequency-selective channel. It is assumed that the transmitter employs linear modulation and that the…
Reconfigurable intelligent surfaces (RIS) are passive controllable arrays of small reflectors that direct electromagnetic energy towards or away from the target nodes, thereby allowing better management of signals and interference in a…
An essential step for achieving multiplexing gain in MIMO downlink systems is to collect accurate channel state information (CSI) from the users. Traditionally, CSIs have to be collected before any data can be transmitted. Such a sequential…
We investigate the effect of imperfect feedback on the \epsilon-outage capacity of incremental relaying in the low signal-to-noise ratio (SNR) regime. We show that imperfect feedback leads to a rescaling of the pre-log factor (comparable to…
Most of the non-linear transceivers, which are based on Tomlinson Harashima (TH) precoding and have been proposed in the literature for two-way relay networks, assume perfect channel state information (CSI). In this paper, we propose a…
This paper is on beamforming in wireless relay networks with perfect channel information at relays, the receiver, and the transmitter if there is a direct link between the transmitter and receiver. It is assumed that every node in the…
In this paper, we investigate opportunistic relay and jammer cooperation schemes in multiple-input multiple-output (MIMO) buffer-aided relay networks. The network consists of one source, an arbitrary number of relay nodes, legitimate users…
Two-way relaying is a promising technique to improve network throughput. However, how to apply it to a wireless network remains an unresolved issue. Particularly, challenges lie in the joint design between the physical layer and the routing…
In this paper, we study the performance, in terms of the asymptotic error probability, of a user which communicates with a destination with the aid of a full-duplex in-band relay. We consider that the network is interference-limited, and…
Integrated sensing and communication (ISAC) is a promising technique to provide sensing services in future wireless networks. Numerous existing works have adopted a monostatic radar architecture to realize ISAC, i.e., employing the same…
In this paper, we firstly exploit the inter-user interference (IUI) and inter-cell interference (ICI) as useful references to develop a robust transceiver design based on interference alignment for a downlink multi-user multi-cell…
Cooperative-integrated sensing and communication (C-ISAC) networks have emerged as promising solutions for communication and target sensing. However, imperfect channel state information (CSI) estimation and time synchronization (TS) errors…
In this paper, the problem of maximizing the sum-rate is addressed for a multi-user uplink scenario that is assisted by an active reconfigurable intelligent surface (RIS). The maximization is achieved by optimizing the beamforming at the…
Intelligent reflecting surface (IRS) is a promising new paradigm to achieve high spectral and energy efficiency for future wireless networks by reconfiguring the wireless signal propagation via passive reflection. To reap the potential…
The problem of characterizing the optimal rate achievable with analog network coding (ANC) for a unicast communication over general wireless relay networks is computationally hard. A relay node performing ANC scales and forwards its input…
We consider the optimization of a two-hop relay network based on an amplify-and-forward Multiple-Input Multiple-Output (MIMO) relay. The relay is assumed to derive the output signal by a Relay Transform Matrix (RTM) applied to the input…
In this paper, a novel framework is proposed to optimize the downlink multi-user communication of a millimeter wave base station, which is assisted by a reconfigurable intelligent reflector (IR). In particular, a channel estimation approach…