Related papers: Resonant Frequency Control For the PIP-II Injector…
In preparation for PIP-II, there has been interest in running the Fermilab Booster at a higher current more indicative of the PIP-II era operation. In July 2023, an experiment was performed to study collective instabilities over the…
Two barrier RF systems were fabricated, tested and installed in the Fermilab Main Injector. Each can provide 8 kV rectangular pulses (the RF barriers) at 90 kHz. When a stationary barrier is combined with a moving barrier, injected beams…
The Fermilab Proton Improvement Plan (PIP) was formed in late 2011 to address important and necessary upgrades to the Proton Source machines (Injector line, Linac and Booster). The goal is to increase the proton flux by doubling the Booster…
This paper is concerned with the robust design for a class of switching systems from a fractional order control (FOC) perspective. In particular, the tuning of the robust fractional order PI (RFPI) controller is proposed based on phase…
Reset controllers have demonstrated their effectiveness in enhancing performance in precision motion systems. To further exploiting the potential of reset controllers, this study introduces a parallel-partial reset control structure.…
The ISIS synchrotron at the Rutherford Appleton Laboratory in the UK now routinely uses a dual harmonic RF system to accelerate beam currents in excess of 230uA to run two target stations simultaneously. The acceleration in the ISIS…
Quantum control protocols are typically devised in the time domain, leaving their spectral behavior to emerge only a posteriori. Here, we invert this paradigm. Starting from a target frequency-domain filter, we employ the…
The PIP-II project at Fermilab, which includes an 800-MeV superconducting LINAC, demands rigorous radiation shielding optimization to meet safety requirements. We updated the MARS geometry model to reflect new magnet and collimator designs…
The RFQD is designed to decelerate antiprotons of momentum 100 MeV/c (kinetic energy 5.33MeV)down to a kinetic energy variable between ~10 keV and 120 keV. Inside the RFQ body, at ground potential, the rf structure of the four-rod type is…
It is well known that the tuning of a long radio-frequency quadrupole accelerator is demanding. This study investigated how to realize efficient long RFQ accelerators with multiple shorter and independent cavities. From the RF point of…
We discuss the use of two-dimensional $^{9}$Be$^{+}$ ion crystals for experimental tests of quantum control techniques. Our primary qubit is the 124 GHz ground-state electron spin flip transition, which we drive using microwaves. An ion…
This paper describes the construction and operational status of an accelerator test facility for Project X. The purpose of this facility is for Project X component development activities that benefit from beam tests and any development…
Real-time optimal control remains a fundamental challenge in robotics, especially for nonlinear systems with stringent performance requirements. As one of the representative trajectory optimization algorithms, the iterative Linear Quadratic…
The planned neutrino program at Fermilab requires large proton beam intensities in excess of 2 MW. Measuring the transverse profiles of these high intensity beams is challenging and often depends on non-invasive techniques. One such…
Control electronics for superconducting quantum processors have strict requirements for accurate command of the sensitive quantum states of their qubits. Hinging on the purity of ultra-phase-stable oscillators to upconvert very-low-noise…
The Fermilab Main Injector accelerating cavities have sparking issues when they are run at voltages higher than those required by the PIP-II project. This is a problem Fermilab is working on as planning begins for the next upgrade to the…
Plasma processing has been shown to help mitigate degradation of the performance of superconducting radio-frequency cavities, providing an alternative to removal of cryomodules from the accelerator for refurbishment. Studies of plasma…
Radio-frequency (RF) control is a key technique in cold atom experiments. We present a compact and efficient RF circuit based on a capacitive transformer network, where a low-frequency coil operating up to 30MHz serves as both an intrinsic…
Increasing the Fermilab Main Injector (MI) beam power above ~1.2 MW requires replacement of the 8 GeV Booster by a higher intensity alternative. Earlier, rapid-cycling synchrotron and linac solutions were considered for this purpose. In…
In the context of engineered quantum systems, there is a demand for superconducting tunable devices able to operate with high Q-factors at power levels equivalent to only a few photons. In this work, we developed a 3D microwave reentrant…