Related papers: Withdrawing a solid from a bath: how much liquid i…
In this study, we investigate the stability of a liquid film that partially wets a corner between a cylinder and a substrate, using a combination of theoretical and numerical approaches. The film stability, which depends on the film size…
We perform numerical and experimental studies on the melting process of thin films initiated by a small hole. The presence of a non-trivial capillary surface, namely the liquid/air interface, leads to a few counter-intuitive results: (1)…
Empty liquids represent a wide class of materials whose constituents arrange in a random network through reversible bonds. Many key insights on the physical properties of empty liquids have originated almost independently from the study of…
The dynamics of a thin layer of liquid, between a flat solid substrate and an infinitely-thick layer of saturated vapor, is examined. The liquid and vapor are two phases of the same fluid, governed by the diffuse-interface model. The…
Large scale molecular dynamics simulations are used to study drying suspensions of a binary mixture of large and small particles in explicit and implicit solvents. The solvent is first modeled explicitly and then mapped to a uniform viscous…
The coupled dynamics of two conjugated liquid layers of disparate thicknesses, which coat a solid substrate and are subjected to a transverse temperature gradient, is investigated. The upper liquid layer evolves under the short-wavelength…
Fluids consisting of hard platelike particles near a hard wall are investigated using density functional theory. The density and orientational profiles as well as the surface tension and the excess coverage are determined and compared with…
We present a two-dimensional (2D) mathematical model of a highly concentrated suspension or a thin film of the rigid inclusions in an incompressible Newtonian fluid. Our objectives are two-fold: (i) to obtain all singular terms in the…
From bone and wood to concrete and carbon fibre, composites are ubiquitous natural and engineering materials. Eshelby's inclusion theory describes how macroscopic stress fields couple to isolated microscopic inclusions, allowing prediction…
In this work, we present a solution to the challenging problem of reconstructing liquids from image data. The challenges in reconstructing liquids, which is not faced in previous reconstruction works on rigid and deforming surfaces, lies in…
A liquid poured from a curved solid surface can separate as a steady jet or sheet, or trickle down along the solid surface. It was shown by Duez et al. [Phys. Rev. Lett. 104, 084503 (2010)] that surface wettability controls the separation…
The effect of rigid inclusions on the phase behavior of a film containing a mixture of lipid molecules is investigated. In the proposed model, the inclusion-induced deformation of the film, and the resulting energy cost are strongly…
The influence of a wetting liquid on the coefficient of restitution (COR) is investigated experimentally by tracing freely falling particles bouncing on a wet surface. The dependence of the COR on the impact velocity and various properties…
Consider the flow of a thin layer of non-Newtonian fluid over a solid surface. I model the case of a viscosity that depends nonlinearly on the shear-rate; power law fluids are an important example, but the analysis here is for general…
From hydrogels and plastics to liquid crystals, soft solids cover a wide array of synthetic and biological materials that play key enabling roles in advanced technologies such as 3D printing, soft robotics, wearable electronics,…
The dynamics of thin films on a horizontal solid substrate is investigated in the case of non-Newtonian fluids exhibiting normal stress differences, the rheology of which is strongly non-linear. Two coupled equations of evolution for the…
Thin films, bubbles and membranes are central to numerous natural and engineering processes, i.e., in thin-film solar cells, coatings, biosensors, electrowetting displays, foams, and emulsions. Yet, the characterization and an adequate…
We study the time dependency of the (average) interfacial separation between an elastic solid with a flat surface and a rigid solid with a randomly rough surface, squeezed together in a fluid. We use an analytical theory describing the…
Probing the fluid dynamics of thin films is an excellent tool to study the solid/liquid boundary condition. There is no need for external stimulation or pumping of the liquid due to the fact that the dewetting process, an internal…
Liquid foams are widely used in industry for their high effective viscosity, whose local origin is still unclear. This Letter presents new results on the extension of a suspended soap film, in a configuration mimicking the elementary…