Related papers: Hyper-Selective Plasmonic Color Filters
Plasmonic sensing in the infrared region employs the direct interaction of the vibrational fingerprints of molecules with the plasmonic resonances, creating surface-enhanced sensing platforms that are superior than the traditional…
Imaging below the diffraction limit is always a public interest because of the restricted resolution of conventional imaging systems. To beat the limit, evanescent harmonics decaying in space must participate in the imaging process. Here,…
We present waveguides with photonic crystal cores, supporting energy propagation in subwavelength regions with a mode structure similar to that in telecom fibers. We design meta-materials for near-, mid-, and far-IR frequencies, and…
This paper reports the characterization of hollow metallic waveguides (HMW) to be used as single-mode wavefront filters for nulling interferometry in the 6-20 microns range. The measurements presented here were performed using both…
We propose a novel hybrid mode interferometer (HMI) leveraging the interference of hybridized TE-TM modes in a silicon-on-insulator (SOI) waveguide integrated with a GeSe phase change material (PCM) layer. The SOI waveguide's dimensions are…
Recent works dealt with the optical transmission on arrays of subwavelength holes perforated in a thick metallic film. We have performed simulations which quantitatively agree with experimental results and which unambiguously evidence that…
We investigate through analytic calculations the surface plasmon dispersion relation for monolayer graphene sheets and a separated parallel pair of graphene monolayers. An approximate form for the dispersion relation for the monolayer case…
The photonic band structure of a three-dimensional lattice of metal spheres is calculated using an embedding technique, in the frequency range of the Mie plasmons. For a small filling factor of the spheres, Maxwell-Garnett theory gives an…
Surface plasmon resonance (SPR) sensors built on photonic crystal fibers (PCFs) have recently become a promising category of optical sensing platforms. This is primarily due to their high sensitivity, compact structural design and ability…
The ability to control the spatial distribution of light, particularly in deep sub-wavelength areas, is important for a range of materials science, microscopy, and communications applications. Separately, materials science and…
Plasmons in graphene nanostructures show great promise for mid-infrared applications ranging from a few to tens of microns. However, mid-infrared plasmonic resonances in graphene nanostructures are usually weak and narrow-banded, limiting…
A new form of the filter bank multi-carrier spread spectrum (FBMC-SS) waveform is presented. This new waveform modifies the filtered multi-tone spread spectrum (FMT-SS) system, and is intended to whiten the power spectral density (PSD) of…
We demonstrate a sustainable, lithography-free process for generating non fading plasmonic colors with a prototype device that produces a wide range of vivid colors in red, green, and blue (RGB) ([0-1], [0-1], [0-1]) color space from violet…
Plasmons, collective oscillations of electron systems, can efficiently couple light and electric current, and thus can be used to create sub-wavelength photodetectors, radiation mixers, and on-chip spectrometers. Despite considerable…
Plasmonic, as a rapidly growing research field, provides new pathways to guide and modulate highly confined light in the microwave to the optical range of frequencies. We demonstrate a plasmonic slot waveguide, at the nanometer scale, based…
Nano-scale lasers harnessing metallic plasmons hold promise across physical sciences and industrial applications. Plasmons are categorized as surface plasmon polaritons (SPP) and localized surface plasmons (LSP). While SPP has gained…
This paper presents the work achieved for the manufacturing and characterization of first single-mode waveguides to be used as modal filters for nulling interferometry in the mid-infrared range [4-20 um]. As very high dynamic range is…
A homogeneous negative permeability sphere can support magnetic localized surface plasmons (MLSPs). Generally, negative permeability materials are metamaterial (MM) structures exhibiting very deep subwavelength spatial scales, whose effects…
Plasmonic color printing with semicontinuous metal films is a lithography-free, non-fading, and environment-friendly method of generation of bright colors. Such films are comprised of metal nanoparticles, which resonate at different…
A maskless post-processing technique for CMOS chips is developed that enables the fabrication of RF MEMS parallel-plate capacitors with a high quality factor and a very compact size. Simulations and measured results are presented for…