Related papers: MAC Protocols for IEEE 802.11ax: Avoiding Collisio…
The performances of multimedia applications built on wireless systems depend on bandwidth availability that might heavily affect the quality of service. The IEEE 802.11 standards do not provide performed mechanism for bandwidth management…
The IEEE 802.11ad standard extends WiFi operation to the millimeter wave frequencies, and introduces novel features concerning both the physical (PHY) and Medium Access Control (MAC) layers. However, while there are extensive research…
Increased density of wireless devices, ever growing demands for extremely high data rate, and spectrum scarcity at microwave bands make the millimeter wave (mmWave) frequencies an important player in future wireless networks. However,…
The end-to-end throughput of multi-hop communication in wireless ad hoc networks is affected by the conflict between forwarding nodes. It has been shown that sending more packets than maximum achievable end-to-end throughput not only fails…
In low power wireless sensor networks, MAC protocols usually employ periodic sleep/wake schedule to reduce idle listening time. Even though this mechanism is simple and efficient, it results in high end-to-end latency and low throughput. On…
IEEE 802.11 is a widely used wireless LAN standard which offers a good bandwidth at low cost In an ESS, multiple APs can co-exist with overlapping coverage area. A mobile node connects to the AP from which it receives the best signal.…
Millimeter-wave (mmw) frequency bands, especially 60 GHz unlicensed band, are considered as a promising solution for gigabit short range wireless communication systems. IEEE standard 802.11ad, also known as WiGig, is standardized for the…
Vehicle-to-infrastructure and vehicle-to-vehicle communications has been introduced to provide high rate Internet connectivity to vehicles to meet the ubiquitous coverage and increasing high-data rate internet and multimedia demands by…
Noise is the major problem while working with wireless LAN. In this paper we analyze the noise by using active receiving antenna and also propose the detection mechanism based on RF energy duration. The standard back off mechanism of 802.11…
With the increasing availability of flexible wireless 802.11 devices, the potential exists for users to selfishly manipulate their channel access parameters and gain a performance advantage. Such practices can have a severe negative impact…
Rate control at the MAC-layer is one of the fundamental building blocks in many wireless networks. Over the past two decades around thirty mechanisms have been proposed in the literature. Among them, there are mechanisms that make rate…
In the last decade, there has been a great technological advance in the infrastructure of mobile technologies. The increase in the use of wireless local area networks and the use of satellite services are also noticed. The high utilization…
We present the DeepWiFi protocol, which hardens the baseline WiFi (IEEE 802.11ac) with deep learning and sustains high throughput by mitigating out-of-network interference. DeepWiFi is interoperable with baseline WiFi and builds upon the…
The Wireless Gigabit Alliance (WiGig) and IEEE 802.11ad are developing a multigigabit wireless personal and local area network (WPAN/WLAN) specification in the 60 GHz millimeter wave band. Chipset manufacturers, original equipment…
The rapid development of medical sensors has increased the interest in Wireless Body Area Network (WBAN) applications where physiological data from the human body and its environment is gathered, monitored, and analyzed to take the proper…
The IEEE 802.11 MAC layer utilizes the Carrier Sense Multiple Access with Collision Avoidance (CSMA/CA) mechanism for channel contention, but dense Wi-Fi deployments often cause high collision rates. To address this, this paper proposes an…
Recent experimental studies confirm the prevalence of the widely known performance anomaly problem in current Wi-Fi networks, and report on the severe network utility degradation caused by this phenomenon. Although a large body of work…
The recently released IEEE 802.15.6 standard specifies several physical (PHY) layers and medium access control (MAC) layer protocols for variety of medical and non-medical applications of Wireless Body Area Networks (WBAN). The medical…
The densification and expansion of wireless networks pose new challenges on energy efficiency. With a drastic increase of infrastructure nodes (e.g. ultra-dense deployment of small cells), the total energy consumption may easily exceed an…
This letter proposes a novel random medium access control (MAC) based on a transmission opportunity prediction, which can be measured in a form of a conditional success probability given transmitter-side interference. A transmission…