Related papers: Relating Microstructure and Particle-level Stress …
Structural rearrangement of polystyrene colloidal crystals under dry sintering conditions has been revealed by in situ grazing incidence X-ray scattering. Measured diffraction patterns were analysed using distorted wave Born approximation…
The influence of structural constraints on the relaxation dynamics of three polyurea networks with varying degree of crosslinking, has been studied by means of a thorough analysis of broadband dielectric spectroscopy measurements. Two…
The ground state of colloidal magnetic particles in a modulated channel are investigated as function of the tilt angle of an applied magnetic field. The particles are confined by a parabolic potential in the transversal direction while in…
A crystal plasticity theory was developed for use in simulations of dynamic loading at high pressures and strain rates. At pressures of the order of the bulk modulus, compressions o(100%) may be induced. At strain rates o(10^9)/s or higher,…
The discrete Gaussian model for the surface of a crystal deposited on a disordered substrate is studied by Monte Carlo simulations. A continuous transition is found from a phase with a thermally-induced roughness to a glassy one in which…
The response of metals and their microstructures under extreme dynamic conditions can be markedly different from that under quasistatic conditions. Traditionally, high strain rates and shock stresses are measured using cumbersome and…
We investigate the elastic and yielding properties of two dimensional defect-free mono-crystals made of highly monodisperse droplets. Crystals are compressed between two parallel boundaries of which one acts as a force sensor. As the…
Plastic deformation of crystalline and amorphous matter often involves intermittent local strain burst events. To understand the physical background of the phenomenon a minimal stochastic mesoscopic model was introduced, where…
When glassy materials are rapidly quenched from the liquid to the solid state upon flow cessation or cooling, they solidify in an out-of-equilibrium configuration, retaining the memory of the processing conditions for very long times. This…
This paper describes an experimental study of filtration of a colloidal suspension using microfluidic devices. A suspension of micrometer-scale colloids flows through parallel slit-shaped pores at fixed pressure drop. Clogs and cakes are…
Concentrated particulate suspensions, commonplace in the pharmaceutical, cosmetic and food industries, display intriguing rheology. In particular, the dramatic increase in viscosity with strain rate (shear thickening and jamming) which is…
We study strain-controlled plastic deformation of crystalline solids via two-dimensional discrete dislocation dynamics simulations. To this end, we characterize the average stress-strain curves as well as the statistical properties of…
A coarse-grained molecular dynamics model of linear polyethylene-like polymer chain system was built to investigate the responds of structure and mechanical properties during uniaxial deformation. The influence of chain length, temperature,…
Particle surface chemistry and internal softness are two fundamental parameters in governing the mechanical properties of dense colloidal suspensions, dictating structure and flow, therefore of interest from materials fabrication to…
Local stresses and pressures always exist in glasses. In this letter we consider their effects on the structure and structural correlations in simple glasses. We find that extreme values of local pressures are related to well defined local…
Previous studies demonstrate that grain-boundary sliding could accelerate creep rate and give rise to large internal stresses that can lead to damage development, e.g. formation of wedge cracks. The present study provides more insight into…
Predicting the behaviour of complex systems is one of the main goals of science. An important example is plastic deformation of micron-scale crystals, a process mediated by collective dynamics of dislocations, manifested as broadly…
In the framework of the suggested in [arxiv:1803.08247 [cond-mat.mtrl-sci]] statistical theory of the equilibrium flow stress, including yield strength, ${\sigma}_y$, of polycrystalline materials under quasi-static (in case of tensile…
We discuss how simulations of mechanical properties of materials require descriptions at many different length scales --- from the nanoscale where an atomic description is appropriate, through a mesoscale where dislocation based…
Local segmental relaxation properties of poly(methylmethacrylate) (PMMA) of varying molecular weight are measured by dielectric spectroscopy, and analyzed in combination the equation of state obtained from PVT measurements. The usual…