Related papers: Traceable Coulomb Blockade Thermometry
The thermoelectric properties of a semiconduct quantum dot chain (SQDC) connected to metallic electrodes are theoretically investigated in the Coulomb blockade regime. An extended Hubbard model is employed to simulate the SQDC system…
The thermoelectric properties of quantum dot arrays (QDAs) embedded in nanowires connected to electrodes are studied theoretically in the Coulomb blockade regime. A Hurbbard-Anderson model is used to simulate the electronic contribution to…
The current performances of single-board microcontrollers render them attractive not only for basic applications but also for more elaborate projects, amongst which physics teaching or research. In this article, we show how…
Superconducting circuits provide a versatile and controllable platform for studies of fundamental quantum phenomena as well as for quantum technology applications. A conventional technique to read out the state of a quantum circuit or to…
Impedance measurements provide a useful probe of the physics of bolometers and calorimeters. We describe a method for measuring the complex impedance of these devices. In previous work, stray impedances and readout electronics of the…
The thermodynamic parameters of the superconducting state in Calcium under the pressure at 200 GPa have been determined. The numerical analysis by using the Eliashberg equations in the mixed representation has been conducted. It has been…
We report temperature measurements using a transmon qubit by detecting the population of its first three energy levels, after applying a sequence of $\pi$-pulses and performing projective dispersive readout. We measure the effective…
Bosonic thermal transport through a two-level system is analyzed at temperatures below and comparable to the two-level energy splitting. It is shown that in the low-temperature regime transport is dominated by correlated two-boson processes…
The electronic thermal conductivity of graphene and 2D Dirac materials is of fundamental interest and can play an important role in the performance of nano-scale devices. We report the electronic thermal conductivity, $K_{e}$, in suspended…
Samples of ultracold 174 Yb+ ions, confined in a linear radio-frequency Paul trap, are heated via self-induced micromotion interruption, while their temperature, density, and therefore structural phase are monitored and simulated. The…
This work presents a self-heating study of a 40-nm bulk-CMOS technology in the ambient temperature range from 300 K down to 4.2 K. A custom test chip was designed and fabricated for measuring both the temperature rise in the MOSFET channel…
In this article, we address the problem of how temperature of a quantum system is observed. By proposing a thought experiment, we argue that temperature must be conceived as an operator and its measurement must necessarily accompany a…
Niobium thin film wires were fabricated using electron beam lithography with a four layer liftoff mask system, and subsequently thinned by anodisation. The resistance along the wire was monitored in situ and trimmed by controlling the…
We show measurements of thermal kinetic inductance detectors (TKID) intended for millimeter wave cosmology in the 200-300 GHz atmospheric window. The TKID is a type of bolometer which uses the kinetic inductance of a superconducting…
I investigate the possibility of using Coulomb drag to detect a precursor of the predicted (but as yet not definitively observed) superfluid transition in electron-hole coupled quantum wells. The drag transresisitivity $\rho_{21}$ is shown…
Temperature coefficient of resistance (TCR) of a bolometer can be tuned by modifying the thermal conductance of an absorbing materials since they sense radiations via the temperature change in the absorber. However, the thermal conductance…
We demonstrate the measurement and manipulation of the temperature of cold CO molecules in a microchip environment. Through the use of time-resolved spatial imaging, we are able to observe the phase-space distribution of the molecules, and…
The position noise spectra of six drums on a single chip were measured on a single cooldown below 1.3 kelvin. Cryostat temperatures as low as 0.7 mK were achieved. The temperature dependence of the resonance frequency and linewidth of the…
The reduction of the thermal conductivity in nanostructures opens up the possibility of exploiting for thermoelectric purposes also materials such as silicon, which are cheap, available and sustainable but with a high thermal conductivity…
The reliable measurement and accurate control of the temperature within nanophotonic devices is a key prerequisite for their application in both classical and quantum technologies. Established approaches use sensors that are attached in…