Related papers: An ultra-low noise, high-voltage piezo driver
This work presents a switchable frequency-selective rasorber (SFSR) with two operating modes. Switching from transmission to reflection can be achieved by appropriately adding feeders and PIN diodes based on cascaded two-dimensional lossy…
While our world is filled with its own natural sounds that we can't resist enjoying, it is also chock-full of other sounds that can be irritating, this is noise. Noise not only influences the working efficiency but also the human's health.…
The stable precession region in the spintronic oscillator with an in-plane magnetic tunnel junction is very narrow under small external fields, restricting its applications such as for microwave generators. Here we show that this region can…
This paper presents a low-area and low-power consumption CMOS differential current controlled oscillator (CCO) for neuromorphic applications. The oscillation frequency is improved over the conventional one by reducing the number of MOS…
A well-balanced detector with high sensitivity and low noise is presented in this paper. The two-stage amplification structure is used to increase electronic gain while keeping an effective bandwidth of about 70 MHz. In order to further…
This paper presents the first voltage-controlled MEMS oscillator (VCMO) based on a Lithium Niobate (LiNbO3) lateral overtone bulk acoustic resonator (LOBAR). The VCMO consists of a LOBAR in a closed loop with 2 amplification stages and a…
In this paper, low-order models of the frequency and voltage response of mixed-generation, low-inertia systems are presented. These models are unique in their ability to efficiently and accurately model frequency and voltage dynamics…
This paper is the first report of the high-temperature characteristics of a laterally vibrating piezoelectric lithium niobate (LiNbO$_{3}$) MEMS resonator array up to 500{\deg}C in air. After a high-temperature burn-in treatment, device…
A single stage active AC/DC interface able to emulate the optimal load impedance of a Resonant Piezoelectric Vibration Energy Harvester (RPVEH) is proposed. As theoretically shown, unlike an electronic interface that emulates an optimal…
Cavity opto-mechanics enabled radiation pressure (RP) driven oscillators shown in the past offer an all optical Radio Frequency (RF) source without the need for external electrical feedback. However these oscillators require external…
Strongly squeezed light finds many important applications within the fields of quantum metrology, quantum communication and quantum computation. However, due to the bulkiness and complexity of most squeezed light sources of today, they are…
A custom LED driver producing light pulses with very low intensity and O(10 ns) duration was designed and constructed. A microcontroller was employed to handle the amplitudes and the repetition rates of the output pulses. In addition, it…
A new design for an open-hardware Digital-to-Analog Converter System-on-Module is presented for low-noise ion-trap electrode control. The design specifications were established to fill the technical needs of a modular, scalable DC electrode…
We present the realization of a compact micro-wave frequency synthesizer for an atom interferometer based on stimulated Raman transitions, applied to transportable inertial sensing. Our set-up is intended to address the hyperfine…
Electro-optic modulators with low voltage and large bandwidth are crucial for both analog and digital communications. Recently, thin-film lithium niobate modulators have enable dramatic performance improvements by reducing the required…
Magnetic Feshbach resonances are a key tool in the field of ultracold quantum gases, but their full exploitation requires the generation of large, stable magnetic fields up to 1000 G with fractional stabilities of better than $10^{-4}$.…
Multilayer piezoelectric polyvinylidene fluoride (PVDF) actuators are a promising approach to enhance performance of soft microrobotic systems. In this work, we develop and characterize multilayer PVDF actuators with parallel voltage…
A 20 GHz LLRF system is being built using a two-board(RF Front End + ADC/DAC/FPGA) architecture. The RF Front End provides 8 down-converting channels and 3 up-converting channels (5.5-20 GHz RF to 0.05-3 GHz IF). Separate, phase locked,…
Scaling of multi-pixel cryogenic detectors for imaging becomes increasingly difficult with size due to complexity of readout circuitry and cryogenic constraints (thermal load from wiring). We propose and demonstrate a new readout scheme…
This paper proposes a low-power and low-noise instrumentation amplifier (IA) tailored for bioimpedance sensing applications. The design originates from a gain-boosted flipped voltage follower (FVF) transconductance (TC) stage and integrates…