Related papers: An ultra-low noise, high-voltage piezo driver
We present an inexpensive, low-noise ($<260~\mu$V$_{rms}$, 0.1~Hz - 100~kHz) design for a piezo driver suitable for frequency tuning of external-cavity diode lasers. This simple driver improves upon many commercially available drivers by…
We present a design for a radio-frequency driver that leverages telecom amplifiers to achieve high power output and wide bandwidth. The design consists of two compact printed circuit boards (total area $< 255$ cm), which incorporate power…
We report in this paper the design, fabrication and experimental characterization of a piezoelectric MEMS microgenerator. This device scavenges the energy of ambient mechanical vibrations characterized by frequencies in the range of 1 kHz.…
We present a low-noise, high modulation-bandwidth design for a laser current driver with excellent long term stability. The driver improves upon the commonly-used Hall-Libbrecht design. The current driver can be operated remotely by way of…
We present the design process and implementation of fully open-source, ultra-low noise programmable current source systems in two configurations. Although originally designed as coil drivers for Optically Pumped Magnetometers (OPMs), the…
This paper presents an output capacitor-less low-dropout regulator (LDO) with a bias switching scheme for biomedical applications with dual-range load currents. Power optimization is crucial for systems with multiple activation modes such…
An ultra-low-voltage crystal quartz oscillator is proposed. The approach to its design is essentially based on using a HEMT operating in unsaturated dc regime and a quartz resonator as a resonant impedance transformer. The 25 MHz prototype…
We present a piezo-driven translatable mirror with excellent pointing stability, capable of driving at frequencies up to tens of kilohertz. Our system uses a tripod of piezo actuators with independently controllable drive voltages, where…
Optically generated microwave signals exhibit some of the lowest phase noise and timing jitter of any microwave-generating technology to date. The success of octave-spanning optical frequency combs in down-converting ultrastable optical…
This article is present high precision multiwave rectifier circuit operating in low voltage plus or minus 1.5 Volt current modes by CMOS technology 0.5 \mum, receive input and give output in current mode, respond at high frequency period.…
In this paper a CMOS operational amplifier is presented which operates at 2V power supply and 1microA input bias current at 0.8 micron technology using non conventional mode of operation of MOS transistors and whose input is depended on…
We report the design and characterization of an optical shutter based on a piezoelectric cantilever. Compared to conventional electro-magnetic shutters, the device is intrinsically low power and acoustically quiet. The cantilever position…
We present a high bandwidth piezoelectric-actuated mirror for length stabilization of an optical cavity. The actuator displays a transfer function with a flat amplitude response and greater than 135$^\circ$ phase margin up to 200 kHz,…
Piezoelectric resonators are a common building block for signal processing because of their miniature size, low insertion loss, and high quality factor. As consumer electronics push to millimeter waves frequencies, designers must increase…
Fluidic valves based on the Coand\u{a} effect are increasingly being considered for use in aerodynamic flow control applications. A limiting factor is their variation in switching time, which often precludes their use. The purpose of this…
Demand for on-chip low-dropout regulators (LDOs) with both high power-supply rejection ratio (PSRR) and fast transient response is growing as system-on-chip (SoC) integration increases. However, conventional LDO architectures face…
A stable low dropout (LDO) voltage regulator topology is presented in this paper. LDOs are linear voltage regulators that do not produce ripples in the DC voltage. Despite the close proximity of the supply input voltage to the output, this…
The generation and manipulation of ultracold atomic ensembles in the quantum regime require the application of dynamically controllable microwave fields with ultra-low noise performance. Here, we present a low-phase-noise microwave source…
A novel design for a low dropout (LDO) voltage regulator is presented and dedicated to power many sections of a typical cellular handset. However, these baseband, RF, and audio sections have different requirements that influence which LDO…
Lowering the operating voltage of electrooptic modulators is desirable for a variety of applications, most notably in analog photonics , and digital data communications . In particular for digital systems such as CPUs, it is desirable to…