Related papers: IBIC analysis of CdTe/CdS solar cells
(Abridged) Aims: In this paper, we seek to establish the suitability of imaging spectroscopy performed in the Ca II 854.2 nm line as a means to investigate the solar chromosphere at high resolution. Methods: We utilize monochromatic images…
Charge Coupled Devices (CCDs) have been successfully used in several high energy physics experiments over the past two decades. Their high spatial resolution and thin sensitive layers make them an excellent tool for studying short-lived…
The purpose of this project is to investigate the use of charge couple devices (CCDs) to detect electrons directly. This can be done in transmission electron microscopy (TEM) for electrons over 100 KeV, but for space plasma instruments,…
Nano-scaled metallic or dielectric structures may provide various ways to trap light into thin-film solar cells for improving the conversion efficiency. In most schemes, the textured active layers are involved into light trapping structures…
Investigation of HV-CMOS sensors for use as a tracking detector in the ATLAS experiment at the upgraded LHC (HL-LHC) has recently been an active field of research. A potential candidate for a pixel detector built in Silicon-On-Insulator…
In integrated photonics, specific wavelengths are preferred such as 1550 nm due to low-loss transmission and the availability of optical gain in this spectral region. For chip-based photodetectors, layered two-dimensional (2D) materials…
In general, perovskite solar cells (PSC) with a sensitized or thin film architecture absorb light from a single illumination. This paper reported a PSC architecture with a semitransparent Au/ITO counter electrode, which allows light to pass…
The thermodynamic limit of photovoltaic efficiency for a single-junction solar cell can be readily predicted using the bandgap of the active light absorbing material. Such an approach overlooks the energy loss due to non-radiative…
We explore CdTe fractional monolayer quantum dots (QDs) in a ZnCdSe host matrix for potential application in an intermediate band solar cell device. Careful consideration has been taken during the initiation of the growth process of QDs by…
We present direct measurements of depth-resolved band gap variations of CuIn(1-x)Ga(x)Se2 thin-film solar cell absorbers. A new measurement technique combining parallel measurements of local thin-film interference and spectral…
Spin-cast all-inorganic nanoparticle solutions have been used to make a CdTe/CdSe solar cell with an efficiency of up to 2.8% without alumina or calcium buffer layers. The type of junction and non-selective nature of the contacts made to…
In a multi-electrode device, the motion of free charge carriers generated by ionizing radiation induces currents on all the electrodes surrounding the active region [1]. The amount of charge induced in each sensitive electrode is a function…
The unique electrical and material properties of 4H-silicon-carbide (4H-SiC) make it a promising candidate material for high rate particle detectors. In contrast to the ubiquitously used silicon (Si), 4H-SiC offers a higher carrier…
We investigated the possibility of augmenting the fluence of electrons traversing CdTe thin film and thus increasing the detected signal pursuing two venues: adding a high-Z metal layer to the back of the detector surface, and adding a top…
Electrodes in sodium-ion batteries endure mechanical stress during production and application, which can damage these fragile coatings, causing performance inefficiencies and early failure. Binder material provides elasticity in electrode…
Following the recent success of monolithically integrated Perovskite/Si tandem solar cells, great interest has been raised in searching for alternative wide bandgap top-cell materials with prospects of a fully earth-abundant, stable and…
We present a comprehensive study of the electronic, magnetic, and optical properties of CuGa$_{1-x}$Fe$_x$S$_2$, as a promising candidate for intermediate-band (IB) solar cells. We use hybrid exchange-correlation functional within the…
Efficient semi-transparent solar cells can trigger the adoption of building integrated photovoltaics. Halide perovskites are particularly suitable in this respect owing to their tunable bandgap. Main drawbacks in the development of…
Supercapacitors, S-C - capacitors that take advantage of the large capacitance at the interface between an electrode and an electrolyte - have found many short-term energy applications. We concentrate here on optically induced, electrical…
A two-dimensional model was developed to simulate the optoelectronic characteristics of indium-gallium-nitride (InGaN), thin-film, Schottky-barrier solar cells. The solar cells comprise a window, designed to reduce the reflection of…