Related papers: SUMMeR: Sub-Nyquist MIMO Radar
The large beamforming gain used to operate at millimeter wave (mmWave) frequencies requires obtaining channel information to configure hybrid antenna arrays. Previously proposed wideband channel estimation strategies, however, assume…
Recently, deep learning has been proposed as a potential technique for improving the physical layer performance of radio receivers. Despite the large amount of encouraging results, most works have not considered spatial multiplexing in the…
In this paper, we investigate the multiple-input multiple-output (MIMO) transceiver design under an interesting power model named mixed power constraints. In the considered power model, several antenna subsets are constrained by sum power…
The multiple-input multiple-output (MIMO) detection problem is a fundamental problem in modern digital communications. Semidefinite relaxation (SDR) based algorithms are a popular class of approaches to solving the problem because the…
Tomographic synthetic aperture radar (TomoSAR) imaging algorithms based on deep learning can effectively reduce computational costs. The idea of existing researches is to reconstruct the elevation for each range-azimuth cell in…
Frequency modulated continuous wave (FMCW) radar is widely used in autonomous driving and industrial inspection due to its high-resolution target location and velocity estimation capability. However, the plethora of connected devices in…
Radar for deep learning-based human identification has become a research area of increasing interest. It has been shown that micro-Doppler ($\mu$-D) can reflect the walking behavior through capturing the periodic limbs' micro-motions. One…
Multiple Input Multiple Output (MIMO) systems have recently emerged as a key technology in wireless communication systems for increasing both data rates and system performance. There are many schemes that can be applied to MIMO systems such…
It has been shown that analog-to-information con- version (AIC) is an efficient scheme to perform sub-Nyquist sampling of pulsed radar echoes. However, it is often impractical, if not infeasible, to reconstruct full-range Nyquist samples…
We investigate the one-bit MIMO (1b-MIMO) radar that performs one-bit sampling with a time-varying threshold in the temporal domain and employs compressive sensing in the spatial and Doppler domains. The goals are to significantly reduce…
This paper proposes a joint transmitter-receiver design to minimize the weighted sum power under the post-processing signal-to-interference-and-noise ratio (post-SINR) constraints for all subchannels. Simulation results demonstrate that the…
In multi-user millimeter wave (mmWave) multiple-input-multiple-output (MIMO) systems, hybrid precoding is a crucial task to lower the complexity and cost while achieving a sufficient sum-rate. Previous works on hybrid precoding were usually…
Traditional multiple input multiple output radars, which transmit orthogonal coded waveforms, suffer from range-azimuth resolution trade-off. In this work, we adopt a frequency division multiple access (FDMA) approach that breaks this…
Millimeter-wave (mmW) radar is widely applied to advanced autopilot assistance systems. However, its small antenna aperture causes a low imaging resolution. In this paper, a new distributed mmW radar system is designed to solve this…
In this paper, we investigate jointly sparse signal recovery and jointly sparse support recovery in Multiple Measurement Vector (MMV) models for complex signals, which arise in many applications in communications and signal processing.…
The Internet of things (IoT) holds much commercial potential and could facilitate distributed multiple-input multiple-output (MIMO) communication in future systems. We study a distributed reception scenario in which a transmitter equipped…
This paper studies the performance of single-input multiple-output (SIMO) systems under receive antenna selection (RAS) and BPSK/QPSK modulations. At the receiver, a subset of branches are selected and combined using maximal-ratio combining…
Sensing emerges as a critical challenge in 6G networks, which require simultaneous communication and target sensing capabilities. State-of-the-art super-resolution techniques for the direction of arrival (DoA) estimation encounter…
Multiple-input, multiple-output (MIMO) technology provides high data rate and enhanced QoS for wireless com- munications. Since the benefits from MIMO result in a heavy computational load in detectors, the design of low-complexity…
In this work, we derive the maximum a posteriori (MAP) symbol detector for a multiple-input multiple-output system in the presence of Wiener phase noise due to noisy local oscillators. As in single-antenna systems, the computation of the…