Related papers: A Modular Data Acquisition System using the 10 GSa…
To test and calibrate various detectors in nuclear and high energy physics experiments, a general purposed calibration instrument has been developed. All information including timing, amplitude and charge of signals can be directly obtained…
The purpose of this project was to design and implement a pipeline Analog-to-Digital Converter using 0.35um CMOS technology. Initial requirements of a 25-MHz conversion rate and 8-bits of resolution where the only given ones. Although…
Massive multiple-input multiple-output (M-MIMO) is an enabling technology of 5G wireless communication. The performance of an M-MIMO system is highly dependent on the speed and accuracy of obtaining the channel state information (CSI). The…
We present the first single-input multiple-output (SIMO) receiver ASIC that jointly performs jammer mitigation, channel estimation, and data detection. The ASIC implements a recent algorithm called siMultaneous mitigAtion, Estimation, and…
We demonstrate a real-time implementation of multi-target detection and tracking using 5G New Radio (NR) physical downlink shared channel (PDSCH) waveform with 400 MHz bandwidth at 28 GHz carrier frequency. The hardware platform is built on…
The Data Acquisition System of the LZ experiment, the 10-tonne dark matter detector to be installed at the Sanford Underground Research Facility (SURF), will collect signals from 788 photomultiplier tubes (PMTs). Because the signals from…
We propose a unified Transformer-based architecture for wireless signal processing tasks, offering a low-latency, task-adaptive alternative to conventional receiver pipelines. Unlike traditional modular designs, our model integrates channel…
We present a 22 nm FD-SOI (fully depleted silicon-on-insulator) application-specific integrated circuit (ASIC) implementation of a novel soft-output Gram-domain block coordinate descent (GBCD) data detector for massive multi-user (MU)…
FSUDAQ is a versatile, multi-threaded, lightweight data acquisition software with a graphical user interface, designed to fully utilize the capabilities of first-generation CAEN x725, x730, and x740 series digitizers equipped with various…
A prototype of proton counter was developed by the University and the National Institute for Nuclear Physics of Torino to be used as online fluence beam monitor in particle therapy. The single particle identification approach aims at…
Modern physics experiments often utilize FPGA-based systems for real-time data acquisition. Integrated analog electronics demand for complex calibration routines. Furthermore, versatile configuration and control of the whole system is a key…
Low-resolution analog-to-digital converters (ADCs) are promising for reducing energy consumption and costs of multiuser multiple-input multiple-output (MIMO) systems with many antennas. We propose low-resolution multiuser MIMO receivers…
The data acquisition system (DAQ) for a highly granular analogue hadron calorimeter (AHCAL) for the future International Linear Collider is presented. The developed DAQ chain has several stages of aggregation and scales up to 8 million…
Planar Fourier capture arrays (PFCAs) are optical sensors built entirely in standard microchip manufacturing flows. PFCAs are composed of ensembles of angle sensitive pixels (ASPs) that each report a single coefficient of the Fourier…
Analog beamforming is an attractive and cost-effective solution to exploit the benefits of massive multiple-input-multiple-output systems, by requiring only one up/down-conversion chain. However, the presence of only one chain imposes a…
This paper describes the design and development of low cost USB Data Acquisition System (DAS) for the measurement of physical parameters. Physical parameters such as temperature, humidity, light intensity etc., which are generally slowly…
Deep learning has been widely applied to 3D medical image segmentation tasks. However, due to the diversity of imaging modalities, the high-dimensional nature of the data, and the heterogeneity of anatomical structures, achieving both…
We present the design principle and test results of a data transmitting ASIC, GBS20, for particle physics experiments. The goal of GBS20 will be an ASIC that employs two serializers each from the 10.24 Gbps lpGBT SerDes, sharing the PLL…
We consider a signaling format where the information to be communicated from one or multiple transmitters to a receiver is modulated via a superposition of independent data streams. Each data stream is formed by error-correction encoding,…
Fully Field Programmable Gate Array (FPGA)based digitizer for high-resolution time and energy measurement is an attractive low cost solution for the readout electronics in positron emission computed tomography (PET)detector. In recent…