Related papers: Beamforming Design for Full-Duplex Two-Way Amplify…
Full Duplex (FD) radio has emerged as a promising solution to increase the data rates by up to a factor of two via simultaneous transmission and reception in the same frequency band. This paper studies a novel hybrid beamforming (HYBF)…
Millimeter Wave (mmWave) communications with full-duplex (FD) have the potential of increasing the spectral efficiency, relative to those with half-duplex. However, the residual self-interference (SI) from FD and high pathloss inherent to…
Full-duplex (FD) technology is envisaged as a key component for future mobile broadband networks due to its ability to boost the spectral efficiency. FD systems can transmit and receive simultaneously on the same frequency at the expense of…
In this paper, the filter-and-forward (FF) relay design for multiple-input multiple-output (MIMO) orthogonal frequency-division multiplexing (OFDM) systems is considered. Due to the considered MIMO structure, the problem of joint design of…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
In this paper, we analyze the performance of a two- way subcarrier intensity-modulated (SIM) amplify-and-forward (AF) relaying system over free-space optics (FSO) communication channels. The analysis takes into consideration attenuations…
Residual self-interference (SI) cancellation in the digital baseband is an important problem in full-duplex (FD) communication systems. In this paper, we propose a new technique for estimating the SI and communication channels in a FD…
Virtual full-duplex (VFD) is a powerful solution to compensate the rate loss of half-duplex relaying without the need to full-duplex capable nodes. Inter-relay interference (IRI) challenges the operation of VFD relaying systems. Recently,…
In-band full-duplex (FD) communication provides a promising alternative to half-duplex (HD) for wireless systems, due to increased spectral efficiency and capacity. In this paper, HD and FD radio implementations of two way, two hop and two…
The hybrid half-duplex/full-duplex (HD/FD) relaying scheme is an effective paradigm to overcome the negative effects of the self-interference incurred by the full-duplex (FD) mode. However, traditional hybrid HD/FD scheme does not consider…
Designing beamforming techniques for the downlink (DL) of frequency division duplex (FDD) massive MIMO is known to be a challenging problem due to the difficulty of obtaining channel state information (CSI). Indeed, since the…
We consider a bidirectional in-band full-duplex (FD) multiple-input multiple-output (MIMO) system subject to imperfect channel state information (CSI), hardware distortion, and limited analog cancellation capability as well as the…
This paper studies the secure beamforming design in a multiple-antenna three-node system where two source nodes exchange messages with the help of an untrusted relay node. The relay acts as both an essential signal forwarder and a potential…
In this work, we consider a dual-hop, decode-and-forward network where the relay can operate in full- duplex (FD) or half-duplex (HD) mode. We model the residual self-interference as an additive Gaussian noise with variance proportional to…
Integrated sensing and communication (ISAC) has been envisioned as a solution to realize the sensing capability required for emerging applications in wireless networks, while efficiently utilizing the available spectral, hardware and energy…
This paper deals with distributed beamforming techniques for wireless networks with half-duplex amplify-and-forward relays. Existing schemes optimize the beamforming weights based on the assumption that channel state information (CSI) is…
The recent attempts to realize full-duplex (FD) communications in millimeter wave (mmWave) systems have garnered a significant amount of interest for its potential. In this paper, we present a cost-efficient design of mmWave FD systems,…
We derive closed-form expressions for the achievable rates of a buffer-aided full-duplex (FD) multiple-input multiple-output (MIMO) Gaussian relay channel. The FD relay still suffers from residual self-interference (RSI) after the…
Relay systems improve both coverage and system capacity. Towards this direction, full-duplex (FD) technology, being able to boost the spectral efficiency by transmitting and receiving simultaneously on the same frequency and time resources,…
With the help of an in-band full-duplex relay station, it is possible to simultaneously transmit and receive signals from multiple users. The performance of such system can be greatly increased when the relay station is equipped with a…