Related papers: An analytical model for the influence of contact r…
The influence of electrical and thermal contact resistance on the efficiency of a segmented thermoelectric generator is investigated. We consider 12 different segmented $p$-legs and 12 different segmented $n$-legs, using 8 different…
A thermoelectric device is a heat engine that directly converts heat into electricity. Many materials with a high figure of merit ZT have been discovered in anticipation of a high thermoelectric efficiency. However, there has been a lack of…
Accurate measurement of efficiency for thermoelectric generator (TEG) is of great importance for materials research and development. Approximately all the parameters of a material are temperature dependent, so we can't directly apply the…
We report the machine learning (ML)-based approach allowing thermoelectric generator (TEG) efficiency evaluation directly from 5 parameters: 2 physical properties - carriers density and energy gap, and 3 engineering parameters - external…
In a recent article, Baranowski et al. [J. Appl. Phys. 113, 204904 (2013)] proposed a model that allegedly facilitates optimization of thermoelectric generators operation as these latter are in contact with hot and cold temperature baths…
Estimation of thermal contact resistances between cylinders can be achieved using heating on the cross sections by a laser spot and measurement of the temperature response by IR thermography. This type of measurement makes it possible to…
A 3D thermoelectric numerical model is used to investigate different internal heat loss mechanisms for a thermoelectric generator with bismuth telluride p- and n-legs. The model considers all thermoelectric effects, temperature dependent…
We study how maximum output power can be obtained from a thermoelectric generator(TEG) with nonideal heat exchangers. We demonstrate with an analytic approach based on a force-flux formalism that the sole improvement of the intrinsic…
We consider the thermodynamic properties of systems in contact with an information source and focus on the consequences of energetic cost associated with the exchange of information. To this end we introduce the model of a thermal tape and…
Thermal energy can be directly converted to electrical energy as a result of thermoelectric effects. Because this conversion realises clean energy technology, such as waste heat recovery and energy harvesting, substantial efforts have been…
Improvement of thermoelectric systems in terms of performance and range of applications relies on progress in materials science and optimization of device operation. In this chapter, we focuse on optimization by taking into account the…
Thermoelectric materials open a way to harness dissipated energy and make electronic devices less energy-demanding. Heat-to-electricity conversion requires materials with a strongly suppressed thermal conductivity but still high electronic…
A thermoelectric generator converts a temperature difference into electrical energy. Its energy conversion efficiency is determined by the steady-state temperature distribution inside the generator. By assuming the thermoelectric material…
Significant progress has been made in the field of thermophotovoltaics, with efficiency recently rising to over 40% due to improvements in cell design and material quality, higher emitter temperatures, and better spectral management.…
In this paper we investigate the effect of strong electronic interactions on the thermoelectric properties of a simple generic system, consisting of a single correlated layer sandwiched between two metallic leads. Results will be given for…
The thermoelectric figure of merit ZT, which is defined using electrical conductivity, Seebeck coefficient, thermal conductivity, and absolute temperature T, has been widely used as a simple estimator of the conversion efficiency of a…
In ergonomics and biomechanics, muscle fatigue models based on maximum endurance time (MET) models are often used to integrate fatigue effect into ergonomic and biomechanical application. However, due to the empirical principle of those MET…
Thermal contact has always been a hot issue in many engineering fields and thermal contact resistance (TCR) is one of the important indicators weighing the heat transfer efficiency among the interfaces. In this paper, the contact heat…
We study the physical processes at work at the interface of two thermoelectric generators (TEGs) thermally and electrically connected in series. We show and explain how these processes impact on the system's performance: the derivation of…
Thermoelectric metamaterials featuring width modulation through constrictions (constricted geometries) have emerged as a promising approach for improving heat management and thermoelectric performance. Through a combination of theoretical…